Check and see if you have fuel pressure or try some starter fluid
SOURCE: buick regal 1996 crankshaft position sensor
IF THE CRANK SENSOR GOES BAD ON THAT ENGINE THE CAR WILL STOP RUNNING OR NOT START IF TRYING TO START IT. NEED THE CODE INFO TO HELP YOU FURTHER. TRY GOING TO ADVANCED TO GET THEM TO READ THE CODE-THEY DO THIS FOR FREE.
SOURCE: Low Coolant light flashing on 1996 Buick Regal 3.8
The low coolant sensor should be located in the passenger side radiator tank, You need to take it out and clean the sludge off of it for it to work right. Or you can just unplug it and forget about it, the light will go out and it won't cause any problems.
SOURCE: how to change a fuel pump on a 1996 buick regal
you can access the pump in the trunk remove all the carpet and the is a cover near the back of the rear seat
SOURCE: Crankshaft Position Sensor
the dual crankshaft position sensor is secured in an aluminum mounting bracket and bolted to the left side of the timing chain cover, partially behind the crankshaft balancer, hope this helps get back to me if you need mre help. please rate my fix as i strive to be the best
SOURCE: Buick error code 0141
What does that mean?
This code means that the heated circuit in the oxygen sensor on bank 1 decreases time needed to enter closed loop. As the O2 heater reaches operating temperature, the oxygen sensor responds by switching according to oxygen content of the exhaust surrounding it. The ECM tracks how long it takes for the oxygen sensor to begin switching. It the ECM determines (based on coolant temp) that too much time elapsed before the oxygen sensor began operating properly, it will set P0141. See also: P0135 (Bank 1, Sensor 1).
FB.init("dd7d9e9681341cde77587bc6a2029f6f");
OBD-Codes.com on Facebook
SymptomsYou will likely notice poor fuel economy the illumination of the Check Engine Light.
Causes
A code P0141 may mean that one or more of the following has happened:
Note: Typically a failed catalytic converter does not cause this code. You're more likely to see a P0420 code for a failed converter.
Possible Solutions
62 views
Usually answered in minutes!
×