Cars & Trucks Logo

Related Topics:

D
Dorothy Parker Posted on Apr 14, 2019

Where is the transmission module on a 2003 Mazda 4000what does it look like and can it be on the firewall

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the transfer case control module located on 2008 mazda cx7

https://www.mazdaforum.com/forum/mazda-cx-9-50/where-transmission-control-module-located-part-transmission-43948/
0helpful
1answer

2003 Mazda Tribute. electric switch seems bad, I just want to MANUALY close it. Is this possible? I mean the Sunroof.

Yes you need to remove the roof motor module and then move the sun roof to closed and then reinstall the module.
0helpful
2answers

My fuel emission light is showing on my mazda tribute 2003. Iam just about to trade it in and am wondering if there is cheap way to get it off before i trade it in

Search Results

    Failure of EGR Differential Pressure Sensor : Mazda Tribute ...

    repairpal.com > Problems > Mazda > Tribute
    Check Engine Light and Hesitation or Stumbling While Driving on Mazda Tribute ...this is my second egr valve and car is not picking up the right sped and when ... Mazda Tribute 2003, replacing burnt DPFE, connector bunrt, Need color pinout. ... Drivetrain · Electrical & Lights · Engine · Exhaust & Emissions · Heating & AC ...

    Check Engine Light Diagnosis Cost for Mazda Tribute ...

    repairpal.com > Estimator > Mazda > Tribute
    A Check Engine Light is turned on when the Mazda Tribute engine control module detects a fault in the emissions system. One or more diagnostic codes will be
0helpful
1answer

Location of abs pressure switch on 2003 mazda tribute

probly in the abs module-which is in the brake fluid line--a new module can cost 3000--if the fluid is dark changeit cause it destroys the modules--remembr u can stil brake w out antilock
0helpful
1answer

Where is orifice tube on 2003 Mazda tribute

It is in the high pressure line going to the evaporator like everyone said. My Haynes manual made it look like it was at the connection right at the firewall but it is further upstream than that. There is a compression fitting upstream of the A/C tube fitting that you have to undo. Once you open that part you'll see the orifice tube. Hope this helps
0helpful
2answers

What is tcm on a mazda

The TCM is the Transmission Control Module.
0helpful
1answer

Where is located the transmission speed sensor on a Mazda 3 2006

You'll find the sensor behind the firewall on the axle. To replace it, use a jack to raise the car and reach the sensor (on the driver's side). Remember to drain out the transmission fluid before you begin.
0helpful
1answer

Mazda Protégé ES 2003 with the

if your light is on have codes pulled to tell you what the problem is then go from there
0helpful
2answers

2003 mazda tribute chugging when accelerating engine light flashing as well when accelerating

could be a random misfire, check spark plugs, if that dosen't work you may need to replace coils
1helpful
1answer

Transmission kicks shifting to second gear

This is a known issue with certain '03 and '04 MPV transmissions; my 2003 had the same problem. There is a Mazda technical service bulletin about this - 05-003/004 (Shift Shock). You need to take the van to a qualified shop and have them flash the transmission control module (TCM) with new firmware.

I had this done. It did not completely fix the problem but it did reduce its occurrence.
Not finding what you are looking for?

50 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...