Torque specs on camshaft cap bolts on a 2010 ford ranger 4x4 sport 4.0 V-6

Ricardo Loranca

• 552 Answers
• Posted on Mar 29, 2009

SOURCE: hi there,i need to get a copy of Ford Ranger 2007

check out rockauto.com

SOURCE: I need the rear shock torque specs for a 2007 sport trac

Torque Specifications Description Nm lb-ft lb-in Brake caliper bolt 32 24 — Brake disc shield bolt 8 — 71 Fuel tank filler pipe bracket bolt 15 11 — Fuel tank filler pipe hose clamps 3 — 27 Halfshaft nut and washer 275 203 — Lower arm inboard bolt 250 185 — Lower arm outboard bolt 275 203 — Parking brake cable bracket bolt 10 — 89 Shock absorber lower bolt 275 203 — Shock absorber rod nut 65 48 — Shock absorber upper mount nut 30 22 — Stabilizer bar bracket nut 48 35 — Stabilizer bar link nut and grommet 30 22 — Toe link cam adjuster nut 275 203 — Toe link outboard bolt 325 240 — Trailing arm bolt 300 222 — Upper arm outboard bolt 225 166 — Upper arm inboard nut 250 185 — Wheel speed sensor bolt 8 — 71 Wheel knuckle bolt 275 203 —

SOURCE: head bolt torque for a 1996 ford ranger 2.3liter

it is in the haynes repair manuel and chad is right

SOURCE: head bolt torque spec

Always use new head bolts.
1)tighten to 40ft/lbs
2)back off 1/2 turn
3)tighten back to 40ft/lbs
4)tighten an additional 90 degrees
5)tighten an additional 90 degrees.

SOURCE: i need torque specs on a 1997 ford ranger

I'm assuming you mean for the cylinder head. This tightening sequence starts in the centre, top to to bottom, and then from one side (1 bolt) than to the other side of centre another bolt. Basically you will work in an X patterm one bolt at a time after the 2 centre bolts are tightened. Keep in mind that new head bolts MUST be used. These are called "torque to yield" bolts and permantly stretch during initial install. So, 1. 51 ft lbs and 2. 90-100 degrees. I've done this a long time and basically if you do not have a degree adapter for your torque wrench, it works out to be about 70 ft lbs. Let me know if you need anything else.