Question about Dodge Cars & Trucks

1 Answer

I have a2001 dodge caravan 3.3 I had a misfire on cylinder 2 changed plug wire coil pack red spark instead of blue spark any ideas please help

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Diehard:

    Visited the website for 60 consecutive days.

  • Dodge Master
  • 455 Answers

Need to check 3 things if you have a misfire
spark
fuel
compression

Posted on Apr 11, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 217 Answers

SOURCE: 1998 Cavalier No Spark in cylinders 1 & 4

ignition mod. grounds,pcm or timing belt could all be it but, I would have to look at timing first.

Posted on Jan 17, 2009

ministock48
  • 258 Answers

SOURCE: Ignition coil pack on Ranger 1999 misfire on #3

replace coil

Posted on Oct 23, 2009

  • 110 Answers

SOURCE: i have a 99 grand am SE 2.4 4 cylinder and my

A misfire doesn't always have to be ignition... it's just the most common cause. Faulty or plugged injector, low compression. You need to check fuel pressure and test the fuel injector flow. Then check compression. If you don't have tools for these tests, take it to someone who does. Testing is much cheaper than throwing parts at the problem.

Posted on Feb 25, 2010

  • 819 Answers

SOURCE: I have a 2002 TrailBlazer with the straight

did you replace only one spark plug? that can cause issues because of differences in resistances between cylinders. also, did the map code stay off after replacing
?

Posted on Feb 28, 2010

SOURCE: 99 dodge caravan #4 cylinder misfires, i replaced

This is a known dodge issue replce the injector!!!!! done deal

Posted on May 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 dodge caravan misfires and codes p 2305 and p 2308 comes up. It runs really ruff.


that codes mean ignitoin coil cylinder 2 and 3 posible bad coil pack or spark plug or wires

Oct 29, 2014 | Cars & Trucks

1 Answer

1990 caravan 3.3l motor has spark to cylinders#1 2 3 4 5 but no spark to #6, put new coil pack on, didnt change anything, any ideas


It could be a simple ignition wire problem. Try swapping the #6 wire with one from a known good cylinder and see if the problem follows.

Oct 29, 2013 | Dodge Caravan Cars & Trucks

1 Answer

I need a fix on trouble codesP0304,P0305,P03060,misfire multiple cylinders for 2002 dodge caravan 3.3L v6


all codes will show the same results
Symptoms Symptoms may include:
  • the engine may be harder to start
  • the engine may stumble / stumble, and/or hesitate
  • other symptoms may also be present
Causes A code P0304 may mean that one or more of the following has happened:
  • Faulty spark plug or wire
  • Faulty coil (pack)
  • Faulty oxygen sensor(s)
  • Faulty fuel injector
  • Burned exhaust valve
  • Faulty catalytic converter(s)
  • Running out of fuel
  • Poor compression
  • Defective computer
Possible Solutions If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.
If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.

Jun 23, 2012 | 2002 Dodge Caravan

2 Answers

1996 dodge grand caravan cylinder 3 misfire


Sparkplug
spark wire
distributor cap

Feb 15, 2011 | 1996 Dodge Caravan

1 Answer

Went through some water van died after sitting a day it started up but engine light is now on and sputters when stopped went to auto zone they say i have a 2 cylinder misfire what excactly does this mean...


It means that the number 2 cylinder (passenger front of the engine) is not working. Whether its spark, fuel, or mechanical. The first thing you can check is if there is spark to the cylinder. With the engine running remove the spark plug wire from the number 2 spark plug. Listen or look for spark out of the plug wire. If there isn't than you can check for spark out of the coil pack. Do this with a test light or spark tester. With the engine off remove the number 2 spark plug wire from the coil pack. With the spark tester installed or the test light hooked to ground and placed on the #2 coil post have some body crank the engine over. If ther4e is no spark that you might have a bad coil pack. If there is spark than possibly the plug wire is bad.

You should not drive it with a misfire as you could ruin the catalytic converter which is very expensive to replace.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Dec 01, 2010 | 2000 Dodge Caravan

1 Answer

2006 dodge caravan, 6 cyl. relaced cole, sparkepugs and wires in oct. 2009. Engine is reading #2 cyl. misfire again. Why


Firts time swap spark plug & ignition coil between two different cylinders and read again if the same #2 cyl. misfires !
If #2 cyl. is OK and another cyl. misfires then spark plug or ignition coil is out of order and must be replaced.
If #2 cyl. misfires again then #2 injector must be checked !
If ignition coils & spark plugs (complete set for 6 cyl.) are replaced then you must check #2 injector !

Mar 15, 2010 | 2006 Dodge Caravan

3 Answers

Engine light keeps comeing on mecanic change o2 senser worked for half hour came back on cods keep saying its miss fireing have had this problem for a month know


Start Small work to Big = Saved Money!
The Code(s) should be telling the specific cylinder(s) that are misfiring. Do you know waht the code is?
Target those cylinders 1st before testing the unaffected cylinders.
The following should isolate the problem(s).
1. Spark plugs - take out-reconnect back to wires and test spark plugs for getting sparks. If none: Don't replace them yet. GO TO 2. If the spark plugs are worn, dirty them replace them.
2. Remove spark plugs form end of ignition wires and test for spark from the wire. If none: Don't replace them yet. GO TO 3.
3. Remove the wires from the coil connection and test the coil for spark for each cylinder. If none: Don't replace it yet.
4. Test each spark plug and wires this way.
5. Coil Packs normally provide fire for 2-cylinders at the same time. The two are paired across from one another.
6. Test the coil for fire, amount of fire and if there is both cyclinders firing.
Misfire and the O2 Sensor got replaced??
Good Luck and get back with me if you need additional help or if this solved the problem.

Nov 20, 2009 | 2004 Dodge Intrepid

1 Answer

96 dodge caravan 3.0 has p300 and p306 codes,


A P0306 code means that the the ECM has detected that one of the engine's cylinders is not firing properly. In this case it's cylinder #6.

A code P0306 may mean that one or more of the following has happened:

Faulty spark plug or wire, Faulty coil (pack), Faulty fuel injector, Burned exhaust Valve, Poor compression, and Defective computer. 

Check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the Caravan, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). The number six cylinder is the one towards the radiator and drivers side. If you are going to change all the plugs and wire keep me posted, be glad to help. Good luck and hope this helps, P0300 just means multi miss fire. 

Jun 22, 2009 | 1997 GMC Jimmy

1 Answer

Recurring #2 cylinder misfire.


Hello Mr Fixit...If memory serves me right, the PO352 B fault code would indicate #4 cylinder coil and PO352 A for #3. The
Possible causes ...faulty spark plug...faulty spark plug wire..faulty ignition coil pack..faulty PCM...open or short in wiring from PCM to iginition coil pack. To accurately troubleshoot and determine the problem you will need an oscilliscope and a diagnostic scanner. Without these you are basically guessing as to the cause.
The ignition control module is integrated into the PCM and a faulty ICM can definitely cause this trouble code...and i have seen my share of faulty PCM's.
Hope this helps and the best of luck to ya.

Apr 24, 2009 | 2000 Dodge Dakota Quad Cab

1 Answer

No Start, No Spark, for Grand Caravan 3.8L


we get remans bad out of the box......... good luck

Sep 26, 2008 | 1996 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

84619 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...