SOURCE: 2001 isuzu rodeo has intermittent starting problems
check battery cables & terminals for tightness & corrosion.also check at starter.check starter bolts & actual starter for looseness.if no problems found your starter may be on its way out.next time it happens hit starter with hammer or heavy object if it starts right up get ready to replace it.good luck
SOURCE: 2002 isuzu rodeo won't start
Good day;
the clutch switch is located on the clutch pedal support, if you put your hand on the clutch pedal run your hand up and the switch will be at the top. now if you are going to replace this switch I would try to adjust the switch first the amount of time it takes and this would confirm that it's the switch. ensure clutch pedal is fully returned, disconnect the electrical connector from the switch. loosen lock nut and tighten clutch switch by hand until switch is firmly against clutch lever. back the switch out 1/2 turn, the switch plunger should extend .02-.06" (.5-1.5 mm).
hope this helps
Cheers
SOURCE: Crank Sensor in 94 Isuzu Rodeo
it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)
SOURCE: my 96 Isuzu rodeo won't start and key is stuck in ignition
either that or the ignition switch itself is binding up
Testimonial: "Thank you very much. That should do the trick"
SOURCE: 2002 ISUZU RODEO SE ABS LIGHT IS ON, WHY?
last question as my back hurts from sitting on computer ,right first lift each wheel up and check the wires to the sensors on the wheels ,their is a metal ring with teeth on and what often happens is the wire breaks to the sensor or the metal ring comes loose on the shaft and just spins around .Try this first before you go to a garage who would weld the ring up and charge you for a new computer or something
54 views
Usually answered in minutes!
×