1993 s10 transmission stops responding after it gets moving

How To put a Nissan Into 4 Wheel Drive - YouTube

? 2:09
https://www.youtube.com/watch?v=IirIxH0WIVI
Mar 13, 2011 - Uploaded by suzuki230
Just a quick How To, on putting your Nissan into 4 wheel drive. ... to warn the newbies not to drive on hard surface while in 4WDthis can ... If you're having difficulty engaging the 4wd low gear, you can steer ... Hey man i have a 1991 nissan pathfinder SE im going to install a ... How fast can you go on 4L?.

Nissan Pathfinder Questions - automatic will not go into any ...

www.cargurus.com > Questions > Nissan > Pathfinder

CarGurusautomatic will not go into any gear - was driving and parked. now it wonit go into gear. ... Asked by avips Apr 14, 2010 at 04:02 PM about the 1993 Nissan Pathfinder. Question type: Maintenance & Repair ... 2002 Nissan Pathfinder LE 4WD.

Automatic Transmission May Not Shift Correctly at High ...

repairpal.com > Problems > Toyota > 4Runner

truck periodically will not shift into drive at initial start-up. Will very often shift ... 1990Toyota 4Runner- Automatic Transmission100,000Visitor. I have very similar ...

10 Most Common Transmission Problems

Yep! it does sound as if you've lost the proper connection between your engine flywheel and the transmission clutch-plate. That baby is crying for your TLC after being such a faithful trooper all these years.

part of a clutch job is removing the gearlever make sure the lever is secured properly and selects the gear correctly.
Orherwise your symptoms sound like a collapsed pressure plate or broken release bearing either defective part or something done wrong during installation of clutch

Its Possible the chain in transfer case is stretched I had the same problem a used case was 250 at my local salvage yard

Sorry bud you need a transmission repair or replacement.

Was this tranmission you put in the exact same as the one you replaced? This is not a common issue and I have to lean towards the linkage either binding or out of adjustment, almost like your shifter is not moving far enough to get first and reverse but it has plenty of room to glide through the other gears. Do you have someone who can move the shifter while you get under the truck and watch the linkage to see if it is binding or not traveling far enough. And can you take the linkage off and manually move the transmission cam to go through the gears from under the truck? Please do not get under it while it is started or capable of starting. When it is gera does it operate smoothly and no jerking?

You may have to check the valve for the transmission. Each of the gears has valves which sends the fluid to engage the gear. It may need cleaning or is faulty. Normally this happens when you have debris or dirt in your oil.

Did you put the correct fluid back in the transmission? If it is too heavy weight oil it will cause the synronizers to stick.

well i would check your universal joint's put the parking brake on and block the wheels put the car in n and reach under truck and see if there is play in universal if so need replacement if you have two peace drive shaft check your center support bearing good luck if these check good it could be in transmission good luck redoil

replace the transmission sounds like it is bad.