You mean axle seal.
Watch this video on how to do it.
https://www.youtube.com/watch?v=_-XnccEwpwc
SOURCE: 360 ci Dodge Rear Main Bearing Seal Replacement
Yes ,regardless of which seal is used as you have to loosen main bearings so the crank can be moved down as the seals are crush type and you wont have the clearance to fit the new one,Split seals (2 piece)are the easiest to fit without moving the crank too much.The one piece seal also means trans removal.As far as removing trans completely you may be able to move it back while its being held up by a trolley jack and only pull it back far enough to give you the clearance needed.Autos are far easier than manuals.If its the rope type seal a special tool is used to fit them and its not a tool that is sold just anywhere as that type of seal kept noahs ark from sinking and havnt been used in engines for many many years.
SOURCE: 2004 dodge ram 1500 rear brake light out how to replace?
Open up the tail gate, you will see two torque screws on the inside beside the tail lights. take these out, this will free up the housing and you can change it from there.
SOURCE: Rear drive shaft seal leaking
Yes, but you will need to mark the yoke position and exact number of turns to remove the nut or you will change ring and pinion gear lash setting when re-installing it. You can use a large pipe wrench to hold the yoke still while tightening, or get a special tool made for that.
SOURCE: I have a 2001 Silverado 1500 2wheel drive with
no this is not a thermo issue the heater controls are bad and need to be replaced ive seen this alot in general motor trucks and cars.thanks and good luck
26 views
Usually answered in minutes!
×