The lever in the trunk for the storage bay is no longer operating the storage bay. It is in the down position so not sure why the top won't go down?
Can you manually take the top down?
You need to find out if you have electricity check your fuses first not unless it is the hydraulic but I would check for electricity first blown fuse maybe something got jammed
Loss of hydraulic fluid due to a leak is the likely cause. Defective hydraulic pump motor is another possibility
SOURCE: Gear 1 and reverse gear can no longer be engaged in my Audi A4
Thanks I got the solution it was fixed this morning. One of the gear links was loose and out of place just at the gearbox level
SOURCE: Cant get the Audi A4 jack back into its storage container
Did you wind it all the way down? If so that is the problem, it must be open a few turns to fit back in.
SOURCE: I need to get to the trunk lock mechanism but
The liner is held on by little plastic studs. It can be gently pried off Then you will have access to the lock. The lock should have a nut on it that holds it to the trunk. Turn nut counter-clockwise to remove.
SOURCE: Code P0118 on Audi A4 - Related to Ignition Coil Problem?
Hi, the sensor on the engine (right at the rear end of the cylinder head) has two separate outputs. One drives the temperature gauge and the other provides data for the engine control unit. The output for the engine control unit is almost certainly faulty and the sensor will need to be replaced. It isn't an expensive item and's not time consuming to replace (1/2 hr) - so you could ask Audi to do it for you when they replace the ignition coils.
Hope that helps Matt..
SOURCE: trunk wont open and the back seat wont fold down on our kia optim
By switching the lever you locked the inside trunk release, you will need to put lever back. as far as the trunk you may need to remove the rear seat, pop lower part out and then remove the bolts to the top half of the seat then try to reach the lever so it will open from the inside. i've found that many of these cars with the pop lever inside have sticking trunk locks from not being used, what you do first is spary lock good,with wd40 or pb blaster then slide key in and out and try to turn this may take a whhile but it works then tumbler will free up, you just have to keep spraying inside lock and working the key.
85 views
Usually answered in minutes!
×