SOURCE: gas gauge not working right for 2000 silverado
the only thing that will cause this symptom is the fuel tank sending unit.
SOURCE: I have A 2000 Chevy 3500 Express Van and the brake
Hi,
When you said that you checked the brake switch, did you check it live? Meaning verified live power to the switch, press switch, and then power came out the other terminal?
If so, also verify zero power on brake press, at the offending brake light bulb terminal. You must verify the test light each time you move it...leave running lights on...
After verifying that there is no power coming, after the brake is pressed, note the wire color and find it where it comes to the steering column and test there... This would eliminate wires and connections between front and the rear of the vehicle, unlikely, but needs to be tested.
After verifying no power at that terminal, then yes the t/s switch is certainly suspece. This may be the time to get a mechanic to verify and replace the switch, there are locks, tilt mechanisms, air bags, column bearings, etc involved. Failures risk loss of vehicle control (locking or binding for example.)..
Hope this gets you going in the right direction.
Testimonial: "Thank You. I tried those things and it seemed to be the Emergency Flasher switch in the multi function switch."
SOURCE: gauges blow fuses,brake and turn signal lights dont work
all my gauges quit working and my turnsignals checked all my fuses under the hood and dash whats my problem?
SOURCE: Turn signals and hazard flasher stopped working in
Yes, you are on the right track. More than likely it is a defective flasher relay as one relay controls turn signal and hazard flash. The flasher relay is located behind the left side of the instrument panel.
Testimonial: "clay58 is very knowledgeable. His advice was on the money. Thanks!"
SOURCE: 2000 chevy silverado truck, left turn signals not working
hi
the action which you took were correct.
try checking the wire which is going to the bulb.check for the continuity.
2.bulb socket will be there check the connection in it. if there is any lose connections in it the bulb wont work.
if you get the information which you needed please vote me by clicking the thumbs present in the underside of the page.
48 views
Usually answered in minutes!
×