SOURCE: burned out license plate bulb
open trunk,
remove felt liner from rear of trunk, (liner directly behind rear lights in side trunk) should be 4 plastic Phillips head screws. Loosing screws, then slowly peel liner away. You will see 3 nuts on each side, removing these nuts will loosing the rear light lenses, so you can pull the lense away from the body from the out side to gain access to the license plate bulbs. Re-install in reverse order. While in there I would recommend replacing your brake light and reverse light bulb. Hey your already in there might as well do a little preventive maintance.
SOURCE: How to change a headlight bulb on a 1999 dodge avenger?
under the hood in behind the head light is where the bulb goes dont touch the glass on your new bulb
SOURCE: 1999 Dodge Neon rear license Plate bulb
LICENSE PLATE LAMP BULB
REMOVAL
INSTALLATION
SOURCE: need to replace license plate bulb on my 2005
1. Open the hatch and stand under it.
2. Remove pull handle from the inside of the hatch (2 screws under pop panels).
3. Starting in the lower corners, gently pry the entire interior panel from the hatch,
and leave it hanging from the wiper area near the glass.
4. Grasp the bulb housing and twist to the left while pressing inward.
5. Replace with a 1156 bulb.
SOURCE: license plate bulb needs replacing
Remove license plate. Unscrew the screws on the underside of the bumper. Slide the lights back toward the trunk and then down through the opening. Unscrew bulb and replace with a new one.
Reverse steps to reinstall the lights.
67 views
Usually answered in minutes!
×