No, you should be able to fish the belt over the fan blades, one at a time. Follow this:
Step 1
Open the hood. Disconnect the negative (black) battery cable.
Step 2
Inspect the fan shroud for the accessory belt routing diagram. If the diagram is missing or illegible, use a pen and paper to draw your own diagram before removing the belt. The new belt must be routed around the pulleys exactly as the old one was.
Step 3
Locate the spring loaded belt tensioner on the front of the engine. There is a small pulley attached to the bottom of the tensioner arm.
Step 4
Slide the square end of the breaker bar into the square hole in front of the tensioner pulley. Rotate the breaker bar counterclockwise and the entire tensioner will move enough to relieve the tension from the belt. Pull the belt out from under the pulley and slowly let the breaker bar retract.
Step 5
Remove the accessory belt from each pulley with your hands. Rotate one of the fan blades to the top side of the engine with your hand and pull the belt around it. Repeat this process until the belt is around all of the fan blades. Pull the belt out of the engine compartment.
Step 6
Route the new belt carefully around each fan blade. Wrap the belt around the crankshaft pulley to begin the belt routing process. Refer back to the belt routing diagram instructions to properly route the new belt around the accessory pulleys.
Step 7
Turn the tensioner counterclockwise again with the breaker bar. Position the new belt evenly under the tensioner pulley. Allow the tensioner pulley to tighten against the belt. Pull the breaker bar out of the tensioner.
Step 8
Reconnect the negative battery cable.
SOURCE: HOW TO REMOVE A HEATER CORE IN A 2003 LINCOLN NAVIGATOR
U must remove the entire dash assembly and then the heater core housing which is part of the air distribution box, time to do the job 10-15 hours.
SOURCE: 1999 Lincoln Navigator Heating Problem
if the heater core is getting hot then the problem is the air temp control blend door actuator, a common problem.
SOURCE: 1999 Lincoln Navigator ABS warning light turns on?
One of the ABS sensor's is bad or a hub bearing is bad.Could be front or rear.
SOURCE: fuse box diagram for 1999 lincoln navigator. the
I had this problem last year with my LincolnI. I took it in and for 200 bucks I had to replace a wire that went out of my air suspension. Right after that it drove smooth again.
76 views
Usually answered in minutes!
×