Were is the ecm located on a 2012 crystler 200

Question edited for clarity.
Question moved to model category.

The BCM is located behind the glove box. Open Glove box, empty contents, grab sides of box and push inward a little bit and continue to open door. Once that's done there are 2 modules back there, #1 is ECM #2 is BCM, The BCM has a yellow clip on it.

https://www.google.com/search?q=2013+Ford+Taurus.+Where+is+the+location+of+the+BCM

..

What is the exact ODB code that is present? What are the driving conditions? Slick, ice etc? What kind of shape is the alignment in? Have you had it aligned recently?

The crank sensor is at the rear of the motor. You have to remove the heat shield to get access to the sensor.Check this video out. 2012 Chrysler 200 2 4l crank sensor location

Underhood fuse box. If lid to box is not labeled then owners manual will show location.

There is no resetting a deployed airbag. The air bag module must be replaced and the airbag control module will need replacing along with the seatbelt pre-tensioners.

The sensor is located at the back of the engine in a protected area and out of reach.


For its location and sensor diagram,lick the link below:-----

http://technoanswers.blogspot.com/2012/11/1997-rover-200-crankshaft-sensor.html

-----------
These will help.
Thanks.

It can be faulty fuel regulator or ECM not controlling fuel pump.The fuel pressure regulator and ecm needs to be inspected.For more details,go through the help links.Click the link below:----ECM misfueling Engine?
http://technoanswers.blogspot.in/2012/03/ecm-misfueling-engine.html

----------
How to relieve fuel pressure? http://technoanswers.blogspot.com/2012/01/how-to-relieve-fuel-pressure.html
---------- Refueling problem? http://repairhelpcenter.blogspot.com/2012/01/refueling-problem.html
---------- Vehicle consuming more fuel? http://repairhelpcenter.blogspot.com/2012/01/toyota-tercel-consuming-more-fuel.html
=-------------------- How to maximize fuel economy on your vehicle? http://schematicsdiagram.blogspot.com/2011/11/how-to-maximize-fuel-economy-on-your.html

----------
This will help.
Thanks.

The crank shaft is actually an internal mechanical part of the engine (see last picture) however the crank shaft position sensor uses through what they call a "hall effect" with a componant inside the transmission. The crank shaft turns which in turn turns the componant inside the transmission. Below are a couple of pictures of the location of the crankshaft position sensor as well as what the plug looks like so you know you are removing the correct part. Hope this helps.....

Its under the hood on the passenger side wheelwell in front of the strut tower.

You have a fuel injector problem. you will need to get the car looked at. There may be a recall, because Crystler knows about this, but I cant say that they have put out a recall for sure yet. Just go to Crystlers web site and look up recalls first. My friends Crystler had this exact same problem.