Question about Jeep Cars & Trucks

1 Answer

My jeep chrokee 2.7 crd wont shift when i drive it only uses 1 gear

Its starts nice and goes but it wont change gear it only drives with gear one

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Contributor
  • 7 Answers

The transmission is probably in limp-in mode, and should have an associated check engine light code/DTC. Something like that can be based on sensor issues or an actual problem inside the transmission.

Posted on Mar 18, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 4 wheel drive problem on Jeep YJ

you can also check the 4 wheel drive vacuum switch on top of the transfer case...got mine for 10 bucks from parts store...fixed the problem

Posted on Jan 26, 2009

  • 1 Answer

SOURCE: 1995 cadilac deville has problem shifting from 1 to 2 gear

You don't have torque converter shudder. You don't even mention that in your original post! You def had a solenoid issue. My 94 STS did the same thing. I only had reverse, 1st and 2nd gear. Wouldn't shift outa 2nd period. It was a $200 solenoid repair. Car had a 160K on it when that happened. I have almost 170k on it now. Shifts and works fine. you don't need the tranny replaces ad josavv63 indicates.

Posted on Apr 26, 2009

  • 101 Answers

SOURCE: 2006 jeep chrokee with service 4wheel drive light on

check trans fluid, transfer case fluid and diff fluid, make sure all electrical connections are good.

Posted on Jul 09, 2009

  • 155 Answers

SOURCE: how to change gear shift cable on 2001 dodge dakota 2 wheel drive

the cable goes from the shifter to the transmittion arm,, both cable ends connect via a pin and cotter key (usually) the cable housing (black outside layer) is connected to the shifter frame usaually by a clip and is bolted to the transmittion with a couple bolts on the other end ,, i know this was pertty basic but hope it helped

Posted on Mar 28, 2010

  • 12 Answers

SOURCE: trans in 2000 jetta stuck in thrid

I currently have the same problem, and looking at replacing the transmission wire harness. I'm hoping this will cure my problem. My volkswagon mechanic thinks so anyways.

Posted on Feb 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 chrokee wont shift into 2nd goes straight to third. And does not start in first while driving with the shifter in drive.


It should only start in park or neutral sounds lovely like transmission is it an automatic?

Aug 29, 2015 | Cars & Trucks

1 Answer

Jeep Cherokee 2.8 crd outo box does not engage. It disengaged while driving, now no gears available


is this a transmission problem. this non USA car.
if yes, which one you got.? a/t or m/t and which one.

what year car.
crd diesel.
the cherokee ended here in 2001
but the Lliberty is sold outside USA as a "Cherokee' odd as that is.
and with the CRD (of some type)

no gears, smackes of stick shift. after all A/T never shift gears
they use clutches totally, (but have plenary gear sets)
"NO gears ," does hat mean its stuck in neutral or the wrong gear.
if in neutral the foot clutch slave is leaking, lost all clutch fluid from the filler?
if the gear shift fails to shift, that is another matter, are all gears dead ? and stuck in netural?

May 04, 2015 | Jeep Cars & Trucks

1 Answer

What would stop a transmission from shifting ?


On a newer car this is a mode the transmission goes into when there is a bad problem with the transmission. It will usually go into 2nd gear where you can drive it safely to get it checked out but will not shift into any other forward gears.

Oct 09, 2014 | Cars & Trucks

1 Answer

Jeep runs but will not change gears


automatic? trans, mines a 6speed, and has a clutch.
my guess is yes,
my A/T will not change gears,
all gears slip? (slip , flare or?)
or wont move at all. the car?????
or is stuck in1st gear in drive.?
or wont move in reverse. why not tell full story on so complex a device. super complex it is.
wont up shift , wont down shift
skips gears.
??????????????????

check fuses first.
then scan the PCM, it will tell you errors, called DTCs
use a real scan tool that can scan 2010 Jeeps. (factory codes !!!)
not some autozoned junk.

id bet there is a code, for sure.
even a broken shifter switch, or?

Aug 17, 2014 | 2010 Jeep Wrangler Sahara

1 Answer

My 2005 jeep Cherokee 2.8 crd auto gets stuck in 3rd gear sporadically especially when driving on the freeway. Once it's stuck it won't change up a gear until I stop the vehicle and re-start it. Other


For car not changing gears it can be shifter assembly issue, or it can also be transmission issue. Get the shifter assembly inspected with ignition OFF.

For more troubleshooting, I suggest you to get the Following help link checked, its complete step by step procedure to inspect gear shift issues: -----

GEAR SHIFT ISSUES

http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html

==========

These will help.

Thanks.

Dec 22, 2012 | Cars & Trucks

1 Answer

1993 chevy k1500 transmission problem


Do you mean start the car in drive? if so that problem is inhibitor switch. Other shift problems can be caused by TPS (throttle posistion sensor) if applicable

Oct 05, 2012 | 1993 Chevrolet K1500

1 Answer

2000 Jeep Cherokee Gear Grinding & 4WD Whine sound


Give a try by change your transmission/filters and Transfer case oil.

Oct 27, 2009 | 2000 Jeep Cherokee

3 Answers

My 1989 Jeep with AW4 transmission does not downshift or ?


This model has a tranny computor under the dash on the right side screwed to the bottom of the dash. If I remember correctly, there is also an inline fuse attached to the harness. Check the fuse.

Feb 12, 2009 | 1989 Jeep Cherokee

1 Answer

96 jeep grand chrokee


have you tried turning the truck off and transfering it into all time?

Aug 25, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

84543 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...