Trying to find rear door window attaching clip for Dodge Dakota 2001

No. 1996 was the last of the first generation Dakotas. 2001 is a second generation model, and the body style is quite different.

REMOVAL

1. Remove the watershield. (Refer to 23 - BODY/DOOR - FRONT/WATERSHIELD - REMOVAL)

2. Remove door glass retaining clips and secure the window in the up position using masking tape or equivalent(FRONT DOOR GLASS CLIPS).

3. Disconnect wire connector from power window motor, if equipped.

4. Loosen screws attaching front and rear window guide rails to inner door panel (FRONT DOOR MANUAL WINDOW REGULATOR - TYPICAL).

5. Remove screw heads on guide rails from key hole slots in inner door panel.

6. Loosen screws attaching regulator to inner door panel.

7. Remove regulator from inner door panel.

8. Extract rear guide rail through inner door panel rear access hole (FRONT DOOR POWER WINDOW - TYPICAL).

9. Extract front guide rail through front access hole.

INSTALLATION

1. Insert front guide rail through front access hole.

2. Insert rear guide rail through rear access hole.

3. Place window regulator in position on inner door panel.

4. Place screw heads on guide rails in position through key hole slots in inner door panel.

5. Tighten screws to attach front and rear guide rails to inner door panel.

6. Connect wire connector into power window motor, if equipped.

7. Install door glass.

8. Verify door glass alignment and operation.

9. Install sound shield and door trim panel

DIAGRAMS CAN BE FOUND ON JUSTANSWER,COM

I had the same problem and found the broken lower cable guide laying in the bottom of the door. I drilled 2 holes thru the lower end of the regulator and remounted the guide with 2 screws. I then restrung the cable over the guides (not easy to do) and reinstalled the regulator in the door. It works like new.

you need to replace the Window Regulator.

2001 dakota
I think you should try this website link that I have attached. It helps you repair your vehicle easily without more help. Ask the girl in chat at the bottom of the page on reliable-store com
or try manualslife com but they don't have any live help tho
but both are pretty good

You can call a dodge dealer, give them the vin# and
they used to be able to cut you a key from that.
But if that method is obsolete, you can try this.
If your key was original equipment, roll the window up
and remove the door panel. Remove the clip from the
linkage rod on the door lock. Remove the spring clip
from the door lock assy. and remove the lock.
The door and ignition lock use the same key. Take
the door lock to a locksmith and they will make a
key for you. Hope this helps.

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

on this truck the rear window is glued in with urethane, if I was cutting it out I would use a special power tool designed to do this. I am sorry but this will not be easy with out it, the only thing I could see is you bending and cut the frame off with a scraper and hammer. (bad picture in my mind) might be worth a stop at an auto glass shop and ask them to remove.

you need to push in on door panel at same time in between the door panel and Handel their is a horse shoe clip you will need a "Mechanics DENTAL PICK! to pull it out to release the crank Handel! most part stores will carry that tool!

its not hard guys Take the door trim panel by taking off screws and mirror cover / pull out bottom of door and then sides pull up and outthen take off vapor barrier then look inside of door put tape on glass to hold it up take out bolts on the regulator and exchange it Please rate my response thank you very much