Question about Dodge Durango
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
it is on the passenger side on the back off the motor.there are two allen head bolts or 13mm.it goes into the transmission and normally has rubber at the opening.you should be able to gets this from the top follow middle of valve cover on pass. side the go strait back toward the fire wall.please rate this answer.
Posted on Jan 30, 2009
I have a 2005 neon and i found mu crank sensor on the radiator side of the block driver side of center directly below the starter. I hope this helps..
Posted on Apr 15, 2009
SOURCE: crankshaft sensor
2-0L-2.4L I-4 crankshaft sensor mounts to the engine block, behind the alternator, just above the oil filter. 2.5L V-6 crankshaft sensor mounts to transaxle just below the distributor.
Posted on May 07, 2009
ANSWER: CRANKSHAFT POSITION SENSOR - 4.7L V-8 ENGINE
The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine the cranks sensor is positioned and bolted into a machined hole in the engine block
Disconnect CKP electrical connector at sensor.
Remove CKP mounting bolt CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine
Carefully pry sensor from cylinder block in a rocking action with two small screwdrivers.
Remove sensor from vehicle.
Check condition of sensor o-ring.
Clean out machined hole in engine block.
Apply a small amount of engine oil to sensor o-ring.
Install sensor into engine block with a slight rocking action. Do not twist sensor into position as damage to o-ring may result
CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result.
Install mounting bolt and tighten to 28 N·m (21 ft. lbs.) torque.
Connect electrical connector to sensor.
Posted on Jun 29, 2010
Tips for a great answer:
Nov 26, 2016 | Dodge Cars & Trucks
Crankshaft Position Sensor Operation?
Replace Camshaft position sensor and Crankshaft Position Sensor? http://technoanswers.blogspot.in/2012/06/2005-dodge-durango-replace-camshaft.html
GMC Crankshaft Position (CKP) Sensor Replacing? http://schematicsdiagram.blogspot.com/2011/12/gmc-crankshaft-position-ckp-sensor.html
These details will help.
Nov 25, 2012 | 2000 Cadillac Escalade
Oct 29, 2010 | 2005 Dodge Durango
Jun 24, 2010 | 2001 Dodge Durango
Jun 03, 2010 | 1996 Dodge Ram
Jan 01, 2010 | 1996 Dodge Intrepid
Jan 17, 2009 | 2005 Dodge Ram 2500 Truck
Aug 01, 2008 | 1995 Dodge Caravan
45 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: