I have had the gas levels checked and they are fine, I have tried replacing the pressure switch on the high pressure line and still it won't come on. I have checked the fuses in both locations and they are good, your advice will be appreciated.Cheers Garry
Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it t o me and I thank him even today
They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins
there is one website more but i don't remember its name it was 2 years back bitman something link this
Try these out brother
SOURCE: 1983 sj 800cc 4 stroke 4x4
Hi fathercuda, This grinding noise you have is it consistant through 1-3 in other words is it just when it goes into gear or all the way through to your next shift? also when in neutral do you hear it and if so when you push on the clutch does it stop? This could be a throw out bearing or sincro mesh problem, I am leaning towards the throw out bearing,not a hard fix but a bit of work involved please get back to me with the requested information and see if we can resolve this issue for you good luck
SOURCE: A/C will not work 03 Frontier
Well try it now, and I'm glad you were able to get it fixed, rats eat some of the most unusual stuff! Thanks in advance for the rating!
SOURCE: Nubira 2000 model sticky clutch.
Regards Darryl, you have a leak try bleeding the system then lube the contact ball which you should of done when replacing the slave, also could have master going out happens all the time weakest point in the system is the first to go out.
SOURCE: Acura MDX 2007 Navi Shows Check Engine Oil Level,
Check your oil pressure switch located next to the oil filter. Sounds like that will need to be replaced.
SOURCE: ac was working fine the
Check the low switch by the dryer or accumulator, its a long narrow cannister,
it will have a pressure switch attached to it or near it. put your, ac on high,
pull the molex off the switch and jump the molex with a wire or paperclip,
if the compressor comes on and the ac starts to cool, you will just need
to replace the low pressure switch, if the clutch does not come on,
check the low switch molex to see if there is 12vlts there. good luck!
61 views
Usually answered in minutes!
×