- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
www.dodge.com/download/pdf/manuals/2009-Ram1500-4th.pdf DodgeThis manual illustrates and describes the operation of features and equipment that are either standard or op- tional on this vehicle. This manual may also include ...
Maybe the starter or starter solenoid is bad. First, make sure connections at battery and starter are clean and tight. Old school method: turn headlights on, and (if good and bright) observe them while someone turns key to crank. If they dim noticeably and starter makes no sound, likely the starter has failed. If you observe no difference in headlight strength, then likely the starting circuit from ignition switch to starter solenoid is not working. You could take the wire off starter solenoid and see if it has power there while key is in crank position. If you do have power there, starter needs to be tested, or the solenoid is bad. If no power to the solenoid when cranking, then the circuit from the ignition switch to the solenoid will need diagnosing. Your neutral safety switch, and possibly a starter relay is in that circuit before it reaches the solenoid. Good luck.
Yes, the control system is low power. In theory, this increases reliability and durability in the switch. The likely problem is the power module low beam driver.
Hi, if an engine cranks but refuses to start, it lacks ignition, fuel or compression.
When the engine cranks normally but won't start, you need to check ignition, fuel and compression.
Ignition is easy enough to check with a spark tester or by positioning a plug wire near a good ground. No spark? The most likely causes would be a failed ignition module, distributor pickup or crankshaft position (CKP) sensor.
If it where me I would start considering the only common part between all these effected systems. The ECM although the dealer should be able to say for sure. They have a machine that actually replaces the ECM and can simulate all the sensors. I had to say it but you may need to take it to a dealer for complete diagnostics and repair since the machine is a dealer only type machine.
×