Question about Jeep Cars & Trucks

1 Answer

2000 Jeep cherokee getting to much fuel and won't start

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Jeep Master
  • 4,471 Answers
Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
dr_layinlow
  • 60 Answers

SOURCE: Jeep won;t start..new fuel pump installed

try the fuel filter and make sure you have proper oil pressure!! Remeber if you have tried craking to many bad times then the plugs are going to be fouled out!! Means that they are going to be drowned with gas and need replacing!! Also make sure your fuel pump is coming on!! You should hear a hissin or a hummin noise back from the fuel tank!

Posted on Dec 10, 2008

  • 7 Answers

SOURCE: 2000 Jeep Grand Cherokee Limited Fuel Filter

Sorry brother, it is in the gas tank with the pump. they used filters that are suppose to be good for the life of the vechicle. you can see the plug if you lift up your spare. hope you dont HAVE TO go in there.

Posted on Mar 23, 2009

  • 39 Answers

SOURCE: 2000 Jeep Cherokee Sport cranks but will not start.

Pop off a spark plug wire, insert a screwdriver into the wire (hold onto the handle), hold a 1/4 inch to 1/2 inch away from engine and crank the engine. There should be a spark. If no spark you have a problem with either the ignition system or the ignition system control circuits. Generally if the computer dosen't see a crank signal you will not get a spark (if it doen't see a cam signal you won't get fuel). If no spark from wire try it on each wire. If not a single wire has spark, rent a scan tool from autozone or napa and see if there are any stored codes, also see if any codes come up while cranking. If you can't rent one you can buy a cheap one for under 30-40 dollars. If no codes and no spark the only thing you will have left to try is replacing the coil pack/s. If after replacing the coil packs you still don't have spark you will have to take it into a shop to have it checked out. The reason you would need to take it into a shop is because they will need to plug in a very expensive scan tool(1000-5000 dollars) that will show them all the sensor inputs. Hope this gets you up and running.

Posted on Apr 01, 2009

shadtremonky
  • 353 Answers

SOURCE: Is the fuel pump and the fuel pressure regulator

no, pump is in the tank and the regulator is on the engine

Posted on Jul 01, 2009

ZJLimited
  • 17970 Answers

SOURCE: where is fuel filter in 2000 Jeep Grand Cherokee

For 2000 Jeep Grand Cherokee the Fuel Filter is located under vehicle, driver side, below bed area, front of fuel tank, mounted on chassis in fuel line.

cc3326a.jpg

Fig. Fuel filter/pressure regulator location-1999-01 models




d1426b6.gif


Fig. Fuel filter/pressure regulator-Grand Cherokee

  1. Before servicing the vehicle, please familiarize yourself with safety procedures.
  2. Relieve the fuel system pressure.
  3. Remove or disconnect the following:
    Negative battery cable Fuel supply, return and pressure lines Mounting bolts Fuel filter/pressure regulator
To install:
  1. Install or connect the following:
    Fuel filter/pressure regulator to the body. Torque the bolts to 30 inch lbs. (3 Nm). Fuel pressure, return and supply lines Negative battery cable
  2. Start the vehicle, check for leaks and repair if necessary.


Gooe luck (remember rated this post).

Posted on Jun 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

While driving it would stall suddenly, then restart, then stall, now it won't start?


Checking for spark at the plugs would be the next step.
A mechanic would also check the computer for trouble codes.

Jul 16, 2012 | 2000 Jeep Grand Cherokee

1 Answer

My 2000 jeep grand cherokee will start and drive fine. The check engine will turn on and it will die. Some times i can get it to start and then there is times that it won't. When it don't start, it...


There are many things to do with the engine management system the when the ECM light comes on it can kill the engine. You can go to an autoparts store and they will read the codes for free. Get the code number and description. let me know, i will help. Randy

Jul 30, 2011 | 2000 Jeep Grand Cherokee

2 Answers

My 1998 jeep cheorkee engine turns but won't crank, could it be the computer or what?


it's highly unlikely, there are only two things that can make this happen, not getting fuel (fuel pump failure, fuel pump regulator) or not getting ignition (bad coils, ignition module failure, bad distributor, distributor cap, rotor)

Jun 24, 2011 | 1998 Jeep Cherokee

1 Answer

Fuel fileter


Get under the vehicle and start at the fuel tank and go forward you will find it. If its a Grand Cherokee Laredo the fuel filter is located inside the fuel pump so the whole fuel pump has to be replaced

Nov 30, 2008 | 2000 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

84540 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...