Where's the IAT sensor located on my 2002 Lincoln LS V8

SOURCE: 2002 LINCOLN LS V6 3.0 PCV VALVE LOCATION

it is down under the intake manifold. the intake manifold must be removed to get to it. this vehicle is known for developing a vacum leak in the elbow hose that connects to pcv valve, so ive done a few.

SOURCE: 2002 LS: aHow do I fill radiator in my V8 Lincoln LS...

First- to drain ,you can reach the drain valve,from the pass side,if you lay on the ground and reach up to the radiator. You do not even have to raise the vehicle up
Second- mix Yellow GO5 Coolant about 50/50 or 60/40. Do not use Green in a Ford or Orange GM
To Fill- Remove the front two plastic screw type buttons,from the engine cover
-Remove the cover
The radiator cap is on the front of engine,on top,it is plastic
Remove cap and that is your fill point
Run engine to warm and get thermostat open,as you would with any vehicle
Top off coolant,replace cap
VERY IMPORTANT-next to the Power Brake Booster,and just under it,is a BLEEDER HOSE;to let air out of system. Turn screw slot ,only a little,DO NOT REMOVE SCREW. When coolant runs out close.
Fill-Degas Bottle,to full line,with coolant.
Check the next couple days on resevoir level ( Degas Bottle)

SOURCE: where is the coil pack located on lincoln ls v8 7

Driver side valve cover
7mm socket to remove coil covers and coil

1 thru 4 pass side
5 thru 8 drivers side
Front to back

SOURCE: 2004 lincoln ls v8 defective crank sensor, where

Hi cmalstrom, typically crank sensors are mounted either near or behind the vibration damper (crankshaft pulley), or in one side of the block near the bottom. The sensor will have a connector plugged into it with two wires. Here is a link to the part for your car Crank Sensor. he photo below shows what it looks like with the bolt, and wire connector removed. I hope this helps. :)

Testimonial: "Thanks for the help."

Jeffrey Turcotte

• 8991 Answers
• Posted on Jan 15, 2011

SOURCE: engine diagram showing location of crank sensor on

Hi, be sure to oil the o-ring and twist the new sensor as you push it in.. Please let me know if you have more questions, and thanks for using FixYa.