Question about Jeep Patriot
I think this will help you. I do recomend buying a wire plug install kit.
Posted on Mar 11, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: PIONEER DEH 245
Most aftermarket radios follow the same color code. W G G P, White, Grey, Green, Purple. LF, RF, LR, RR. red is switched ignition, yellow is constant battery, black ground.
Posted on Sep 02, 2008
SOURCE: Wiring A Pioneer DEH P6400
If the factory harness is still in tact, you can buy an adapter at Best Buy for about 20$ or ask to see one and write down the pins and wires then match it up and cut n splice to your new deck. Hope this helps
Posted on Aug 17, 2009
Downloads as a RAR file. make sure you have winzip or winrar, and that should help ya.
Posted on Sep 10, 2009
If to connect in your car, red is constant power (for memory of stations, etc.), and yellow is accessory in your car (when key is turned on to ACC, to power receiver). If receiver used for other application outside of a car, make sure you have enough separate fuse protection and place an ON/OFF switch in series with your yellow wire, to avoid power sorurce being drained.
Hope this helps
Posted on Sep 25, 2009
To run any wire through the firewall, find a spot that is both reachable and unobstructed on both sides of the wall. I generally use a very short bit so after penetrating, it does not accidentally plunge into other wiring or components, or I use a collar over the bit (a small piece of tubing, leaving only 1/4" of bit exposed) I sometimes also "cheat" by poking a hole in the rubber boot where the steering column goes through.
Whenever passing a wire through sheet metal you must install a grommet. (if none are available, you can make one by using a piece of rubber tubing or the cut off end of an old tire valve.)
When tapping power from the battery, you will need to use a relay and switch attached to the "accessory on" side of the ignition switch, to prevent whatever you are installing from remaining on after the vehicle has been turned off. Use fuses in all new power sources as well to protect the vehicle and your new install from damage.
In creating a new circuit, you have the opportunity to use shielded wire, which will prevent stray electrical "noise" in your set" not a bad idea to do that.
Posted on Oct 18, 2009
Tips for a great answer:
Jun 18, 2014 | Jeep 2008 Patriot - AM/FM Navigation with...
Sep 17, 2012 | 2012 Jeep Patriot Sport 4dr SUV 2.0L...
Oct 16, 2010 | Pioneer DEH-P80MP CD Player
Mar 09, 2010 | 2008 Jeep Patriot
Sep 20, 2009 | Pioneer DEH-P4600 CD Player
Aug 10, 2009 | Pioneer DEH-1100 CD Player
Mar 04, 2009 | Pioneer DEH-P6400 CD Player
Feb 06, 2009 | Pioneer AVIC-D2 In-dash Car Audio Stereo...
Mar 24, 2008 | Car Audio & Video
Oct 31, 2007 | Alpine CDM-7874 CD Player
27 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: