Which lead goes to which cap
SOURCE: firing order for a 1986 gmc s15
FIRING ORDERS
To avoid confusion, ALWAYS replace spark plug wires one at a time.
The most important thing to remember about the removal and
installation of a distributor, cap or spark plug cable is that all
wires MUST be labelled before they are disconnected. Keep in mind that
these figures depict a firing order where the distributor cap terminals
are relative to EACH OTHER only and they do not necessarily depict the
tower positions in relation to the rest of the engine. This is true
because any distributor which has been removed and reinstalled may have
been installed with the No. 1 spark plug tower at any position (360
degrees) in relation to the rest of the motor, as long as the rotor
aligned to the No. 1 tower when the No. 1 cylinder was at TDC of the
compression stroke (valves closed, ready for the plug to fire). As long
as the remaining wires were connected in the correct firing order
sequence (depending on direction of distributor rotation) the engine
will run. DO NOT EVER remove more than one wire from the distributor
cap at a time unless you tag ALL wires and towers to assure proper
installation.
Fig. 1: 1.9L engine . Firing order: 1-3-4-2 . Distributor rotation: counterclockwise
Fig. 2: 2.0L engine . Firing order: 1-3-4-2 . Distributor rotation: clockwise
Fig. 3: 2.5L engine . Firing order: 1-3-4-2 . Distributor rotation: clockwise
Fig. 4: 2.8L engine . Firing order: 1-2-3-4-5-6 . Distributor rotation: clockwise
Fig. 5: 4.3L engine. Firing order: 1-6-5-4-3-2 . Distributor rotation: clockwise
I hope help you with this (remember rated this help) Good luck.
SOURCE: firing order diagram for 1986 GMC S15 2.8L
For this models:
1986 GMC S15/T15 4WD P/U 2.8 liter V-6 VIN "R"
1986 GMC S15/T15 4WD Jimmy 2.8 liter V-6 VIN "R"
1986 GMC S15/T15 2WD P/U 2.8 liter V-6 VIN "R"
1986 GMC S15/T15 2WD Jimmy 2.8 liter V-6 VIN "R"
Hope helped woth this. Remember rated this help. Good luck.
SOURCE: distributor cap and spark plug leads order/layout?
The firing order is 1342. The cylinders are numbered from left to right 1234. Depending on wether it is a 16 valve engine, the distributor cap lead number one position is at the front on the left, if its a normal 8 valve engine , the distributor cap lead number one is at the front pointing straight at the front. So, moving anti clockwise, the next lead will be number 3, then 4 , then 2.
SOURCE: Need 95 gmc jimmy vacuum diagram. I have a loose
THat goes to your map sensor. If you look very closely under your hood there will be a vac line diagram there
107 views
Usually answered in minutes!
×