SOURCE: How to Replace the AC filter on my Lexus 01 LX 470
Perform steps 1-3 first to inspect whether you have the access doors or not before ordering filters!!!
Did this little project this evening. Figured I'd write it up.
5 Easy steps:
1. Remove glove box door by removing both screws at the bottom of the door.
2. First pop the the little flap with a fuse/relay out of the black plastic shield in the upper portion of the glove box opening. Next push it back behind the shield through the opening. Next remove the 3 screws holding the shield in place. Don't pull this shield out yet!! Read step 3 first.
3. Gently pull the shield out. Be careful because the glove box light is still plugged into this part. It is located on the right side of the shield. Once it is pulled out slightly, unplug the bulb from the harness and now you can fully remove the part.
4. Now you can see the vertical cover where the air filters reside. The cover is about 5 inches tall and about 1 inch wide. It has 2 tabs on the upper portion of the cover. Squeeze these tabs towards each other and pull the cover off.
5. The filters are now exposed. They are stacked on top of each other. Pull the first filter out then lift the next filter up and pull out. Put new filters back in and reverse the procedure.
Parts needed:
2 Cabin air filters (Toyota PN 88568-60010 if you drop CDan a pm)
1 Phillips screw driver
Time needed:
No more than 15 minutes
STEP BY STEP PHOTO INSTRUCTIONS
Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FERE question.
SOURCE: where is located fuel filter on a lexus 470 year 2004
The fuel filter is located on the front top of the engine.
SOURCE: how does one take off 2008 impala stock radio
You will need an adaptor, there are two for the Impala one does not have door chime one does, cost about $80.oo to $100.oo. You have to pull the trim ring to access the screws. It is best to take it to an audio shop let them do the RnR.
SOURCE: Removing rear tail light in Lexus lx 470
Open the tailgate and then you must unsnap the carpeted part. It's easier with two people as the plastic part that says "Lexus" has to be pulled up out of the way as it will spring back in place if someone is not holding it. Don't be afraid to pull on the carpeted part; it will snap back with ease. When it's off you will see where the lights are. There are three screws you must undo so you can take off the metal cover. Should be pretty easy from there!
SOURCE: remove rear seat lexus es300 2008
the bottom of the rear seat pulls straight up at the front and out. its pretty tight, you need to pull very firmly.
44 views
Usually answered in minutes!
×