SOURCE: 1999 Toyota Corolla interior door handle
There's two screws by the handle, pull those out and you'll see how it all connects on the inside. I was able to remove my broken one, and drill a hole into the plastic where it broke and reuse it - it's lasted over 4 years now.
SOURCE: 1997 Toyota corolla - warning noise when lights left on - not working on drivers side!
The ground circuit for the driver side door switch is compromised, or the door switch is bad. Try this: Remove the black rubber cover from the door swich. Using a 10 millimeter wrench or socket, loosen & tighten the switch retention bolt. See if the dome light flickers. If so, the ground on the switch is bad, & just needs cleaned up. If not, remove the switch, and touch the wire behind the switch to the body,or the bolt hole. If the dome light lights, you need a door switch. Your problem is entirely in the door switch/ground/wiring. Hope this helps, and thanks for choosing FixYa.
SOURCE: How to replace 1998 toyota corolla left door lock
take off the door panel, there will be a aluminum frame behind it, but isnt too hard to work around, its located at the bottom directly under the lock, theres a couple bolts and a wiring harness, and you also need to have the window up to get it out, hope this helps! good luck
SOURCE: 2006 Toyota Corolla. The driver's door won't work with remote.
the actuator might have been disconnected from the lock, its attached inside the door, with a metal rod that clips into the actuator, check it out, might be a easy fix, good luck and god bless, please rate me!
SOURCE: 1994 toyota corolla brake lights won't turn off
Thanks for choosing FixYa and welcome. You need to check the brake switch. Your brake pedal contacts the brake switch when it is pressed down. There is a small button on the brake switch that activates the lights. It may be stuck or broke. Try to loosen the button first. If it won't, buy another one. They only cost a few dollars.
114 views
Usually answered in minutes!
×