Question about Honda Cars & Trucks

1 Answer

I have 2005 Honda Accord that check engine light comes on & off even after buying battery replacing alternator boot intake hose serpentine belt. Is there a fuse that maybe needs to be replace? I also had a diagnostic that cost another $60 which told them it was alternator

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Honda Master
  • 6,815 Answers

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

Posted on Mar 14, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 2005 chevytrailblazer serpentine belt replacement

If it's a 4.2l it is on the left of the vehicle under the power steering pulley. It twists to the right, or clock-wise as you are looking at the engine. Use a 3/8" ratchet handle and possibly an extension.
Good Luck. I'm not sure if you have a v8.

Posted on Feb 27, 2009

  • 6 Answers

SOURCE: check engine light is on in my 2005 Elantra newly maintenanced

Check your engine oil and break oil weather it is in below low level or full, if it has in low level get an engine oil for your car module and pour it. otherwise go to authorized Hyundai service centre and check for it.

Posted on Aug 25, 2009

SOURCE: 2005 Honda Accord heat sensor location

try looking in general area of the thermostat

Posted on Aug 31, 2009

old marine
  • 2237 Answers

SOURCE: Need diagram to replace serpentine belt for 2003 Merc/ Grand Marq

From the Dayco web site:

a4fa8f6.jpg

Posted on Sep 29, 2009

  • 1 Answer

SOURCE: I need the serpentine belt routing diagram for a

where is the diagram !!!!

Posted on Nov 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Honda accord 2005 ex battery light turned on right when i turned it on. Can i continue driving it or not


battery lights do turn on with the ignition and go out when the alternator is charging
if it stays on you are running on the battery and that may give you 15 minutes before it stops the engine
do the firstb check and see if the alternator drive belt is fitted and not broken

May 11, 2018 | Honda Cars & Trucks

1 Answer

Need to know where to find a routing diagram for the serpentine belt on a 2000 honda accord lx 4 cylinder


see the following site that I found by googling "2000 honda accord serpentine belt replacement" You will need to know what engine size and whether you have AC.
https://www.google.com/search?q=2000+honda+accord+serpentine+belt+replacement&client=firefox-a&hs=zDs&rls=org.mozilla:en-US:official&tbm=isch&tbo=u&source=univ&sa=X&ei=ylF4UoS5O6zfsAS8oYCgAg&ved=0CFgQsAQ&biw=1280&bih=896

Nov 04, 2013 | 2005 Honda Accord

1 Answer

My Honda Accord wont start even with a jump. The lights come on but wont turn over. No click, no sound, no nothing


IT's those short drives that burn down a battery! The starting of an engine requires mucho electric to get it running. The alternator then charges the battery, but slowly! If you also have the lights and stereo on it is even slower. Get the battery FULLY charged with a commercial battery charger. Then check to see if the alternator is charging up the battery after you start it. If not, replace the alternator. If the battery dies overnight or in a few days...replace the battery.

Jan 24, 2013 | 2005 Honda Accord

1 Answer

First my ac fan was not blowing as hard as normal still cooling just not blowing, then two days later my battery warning light came on,10 minutes later while running the electrical system just shut down....


Sounds like the alternator has gone bad. Jump start the car and check the voltage at the battery. You should see around 14 volts if the alternator is working. If you see around 12 the alternator is not charging.

Labor rates and parts pricing various greatly depending on where you are. Your best bet to find the most accurate pricing for your area would be to call some local shops to get some phone quotes.

You can expect anywhere from $300 to $600 to have the alternator replaced at a shop. If you do it yourself you can expect to pay $100 to $275 for the alternator at a parts store.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Jul 24, 2012 | 2005 Honda Accord

1 Answer

What's your problem?1995 gmc safari alternator replacement. Need some kind of diagramed overview of the alternator and how it connects, what it looks like, how to do it basically


Hello! First see Serpentine Belt configuration diagram below... Alternator is part "C"...

If you have a voltmeter...read across the battery with engine off...Record...Start engine read again...Voltage must be 1.8 -2 volts higher; This means Alternator is working...

To Remove:disconnect (-) battery cable...Air Inlet Duct...Serpentine Belt (idler pulley maintains tension)...Heater hose brace...Wiring from Alternator...Mounting bolts...Remove alternator...

To Install: Install Alternator loosely...Tighten Rear Bolt to 37 ft. lbs...Front bolt to 18ft. lbsTighten Brace to Intake to 18ft lbs....Connect wiring...Install belt...Adjust Idler Pulley so belt moves less than 3/4" when tight...Connect (-) battery cable....Re-test as noted above...Guru...........Saaile





saailer_129.gif

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Sep 26, 2011 | Cars & Trucks

1 Answer

New battery, partial new alternator but the battery light still comes on at slow speeds?


Usually this type of problem is caused by a loose belt. Sometimes it is an alternator problem, but most of the time a new belt will fix it.

Sep 19, 2011 | 2005 Honda Accord

1 Answer

Replacing the alternator


Fig. : Alternator mounting-2.2L engine

efa282c.jpg

REMOVAL & INSTALLATION

(2.2L Engine)
  1. Disconnect the negative battery cable.
  2. Raise and support the front of the vehicle, then remove the passenger side tire and wheel assembly for access to the rear of the alternator through the wheel well.
  3. Working through the wheel well, unfasten the alternator brace-to-block bolt, then remove the brace-to-intake nut and the brace-to-engine stud nut.
  4. Unplug the alternator wiring connector, then remove the battery terminal nut and wire.
  5. Carefully release the serpentine belt tension and remove the belt from the alternator pulley. Do not allow the tensioner to snap back into position once the belt is off the pulley.
  6. Loosen the alternator retaining bolts, then support the alternator and remove the fasteners. Remove the alternator from the vehicle.

To install:
  1. Position the alternator in the vehicle and loosely install the retaining bolts.
  2. On 1994-98 models, tighten the top alternator bolt to 22 ft. lbs. (30 Nm) and the bottom bolt to 32 ft. lbs. (43 Nm).
  3. On 1999-99 models, tighten the rear bolt to 37 ft. lbs. (50 Nm) and the front bolt to 18 ft. lbs. (25 Nm).
  4. On 1994-98 models, install the alternator brace, then tighten the retaining nut(s) and bolts to 22 ft. lbs. (30 Nm).
  5. On 1999-99 models, install the alternator brace, tighten the brace-to-alternator and brace-to-intake retainers to 18 ft. lbs. (25 Nm). Tighten the brace-to-engine stud nut to 37 ft. lbs. (50 Nm).
  6. Install the battery terminal wire and tighten the retaining nut, then engage the alternator wiring connector.
  7. Hold the serpentine drive belt tensioner, back off the belt while slipping the belt over the alternator pulley. Gradually lower the tensioner into contact with the belt, then check for proper alignment and tension.
  8. Connect the negative battery cable.



Fig. : Alternator mounting-4.3L engine


3fdb6af.jpg

REMOVAL & INSTALLATION
(Except 2.2L Engine)
  1. Disconnect the negative battery cable.
  2. Remove the air inlet duct assembly, if necessary.
  3. Carefully relieve the serpentine drive belt tension, then remove the belt from the alternator pulley. Do not allow the tensioner to snap back into position once the belt is off the pulley.
  4. Remove the nut retaining the radiator hose brace to the back on the alternator.
  5. If equipped, unfasten the retainers, then remove the brace from the engine and/or the alternator.
  6. Disconnect the battery terminal boot wiring from the back of the alternator, then unplug the regulator wiring connector.
  7. Support the alternator and remove the mounting bolts (usually 2) from either side of the alternator, then remove the alternator from the vehicle.
To install:
  1. Position the alternator in the vehicle and loosely install using the mounting bolts.
  2. If equipped, loosely install the brace to the engine and/or alternator.
  3. Tighten the left or front alternator retaining bolts to 36 ft. lbs. (50 Nm), the right or rear alternator bolt to 18 ft. lbs. (25 Nm), the brace bolt to 18 ft. lbs. (25 Nm) and/or the brace nut to 22 ft. lbs. (30 Nm), as applicable.
  4. Connect and secure the alternator wiring.
  5. Carefully relieve the serpentine drive belt tension and position the belt over the alternator pulley, then slowly release the tensioner into position.
  6. If equipped, install the air inlet duct assembly.
  7. Connect the negative battery cable.

I hope helps with this. Good luck (remember rated this help).

Jan 05, 2010 | 1998 Chevrolet S-10 Pickup

2 Answers

93 accord. battery light


Yes it could be the alternator, or more specifically your voltage regulator which is part of your alternator. An auto elec should be able to test it

Jan 25, 2009 | 1993 Honda Accord

1 Answer

Just change my car battery now I have all my gauge lights on like the battery, brake, doors.,seat belts and check engine lights my car is a 1997 Honda accord v6.


it s usually your alternator when batteries lights come on. need to check that , otherwise it will drain your battery

Sep 14, 2008 | 2003 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

84540 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...