2014 1500. Replaced calipers. Why did ABS light turn on?

SOURCE: how to reset the ABS

i think you have metal shavings on the abs wheel sensor. did you go metal to metal on the brakes? new caliper right? disconect the battery for 10 mins that should do it. first clean that sensor off it might reset itself good luck

SOURCE: ABS alarming after I replaced rear brakes shims, bled brakes etc.

try rebleeding the brakes. any air whatsoever will set off the abs light sometimes it takes a few times to get it all out even though they feel good. also make sure the fluid is full that will also set off the light.

SOURCE: 2001 GMC SIERRA . ABS LIGHT STAYS ON

Wheel speed sensors misadjusted, damaged , or metal shavings and other debree, since they are magnetic can give false readings from one of the wheel circuits. Over sized tires can give of false speed readings as well. there are many other causes including bad relay, control module, e.t.c. It is best to have the proper scan tool to diagnose an ABS problem

SOURCE: 1995 GMC Sierra Z71 ABS light stays on

yo man, idk if this is exactly what your problem is but my 1991 gmc sierra was doing the same fuckin thing and ****, and i took it to the gm dealer and had them look at it and my connectors and my ignition switchs were fried, also my truck was having a problem shitfing once those went but i also had that problem, perhaps yours is somehwta liek that as well... hope i could help

SOURCE: 2000 gmc sierra 1500 5.3 v8. a/c heater control problem

your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps

Testimonial: "Very good information. THANKS!"