Possible one of the drive belt (serpentine belt) pulley wheels froze and stopped turning. Ultimately causing the belt to break. You will have to 1st confirm the belt is broken and than why. If all the wheels turn okay, (the large bottom pulley only one not suppose to turn) than check the large one for wrobble when started. Start without belt on but only long enough to see if moves forward and backward.
As jeff said OR just the fanbelt broke and made a noise as it came off. hope it's this... much cheaper then Jeffs scenario
SOURCE: 2005 Dodge Grand Caravan
99% chance it is the blower resister located behind glove box. Squeeze glove box in and pull out.
The resistor is right behind it, dealer part cost less then $20.
Dodge has had this problem for over ten years and until recently did nothing. Now they combine fuse with resistor, suppose that will correct it?
SOURCE: dodge caravan sliding doors
First, keep in mind that as you begin to remove these doors you run the risk of causing serious scratches to the paint and glass, so put some masking tape and/or plastic sheeting around both sides of the door (rear quarter panel and rear glass, front door and front door glass)
I would get a Haynes repair guide since that's what I have to work from and it will tell you step by step with pictures, what to do. It's not hard, but you need to get all of the attach points unhooked to be successful. Suggest you have a helper working with you to keep the door steady.
SOURCE: Airbag dash light
Transport Canada Vehicle Recalls & Defects Database Transport Canada Recall # 2007169 Recall Date: 2007/05/30 Notification Type: Recalls Audit System: Airbag Manufacturer Recall Number: G09 Units Affected: 51,000 Category: Minivan Recall Details: On certain vehicles the left or right front supplemental airbag sensors may crack under certain conditions, which can allow water to enter into the sensor. This can cause the airbag warning lamp to illuminate. A malfunction of one or both of the supplemental sensors will not adversely affect safety or cause a failure to comply with government standards. The single-point sensor in these vehicles, which is located in the airbag control module, is operational even if both supplemental sensors are inoperative. DaimlerChrysler has decided to launch a Customer Satisfaction Notification to advise customers that these front airbag sensors will be replaced with redesigned sensors to reduce the potential for damage. This action is not being conducted under the Motor Vehicle Safety Act.
SOURCE: 2005 Dodge Caravan will not start and engine light flashing 10x
most likely it is the electronic control module which is the brain computer that runs the car and all of the functions and it is not allowing the electrical system to operate or come online. your power supply is not reaching the ignition due to some sort of either an electrical short or blockage.
SOURCE: 2005 dodge caravan engine light code p 441
If you mean code P0441 - This Relates to Incorrect Purge Flow for Evaporative Emission System
55 views
Usually answered in minutes!
×