What does the sonata tps do

SOURCE: replacing rear wheel bearings on 1999 hyundai sonata

1. for drum brakes with sealed hub(all one piece) remove lug nuts and wheel.
2. spray penetrating oil around studs if there is a big phillips head screw visible remove it with impact driver/if not use big ballpeen hammer ,tap on flat of drum near studs(becareful not to hit them) until drum loosens(your creating a shockwave to loosen rust)
3. once drum is off there are 4-bolts coming in from behind backing plate, remove them then hub should be able to be removed w/a little persuation from hammer.

1. remove wheel
2. remove dust cap,cotterpin,star washer(if equipped) do not re use cotter pin
3. remove nut then washer, wiggle brake drum and front bearing will come out.
4. put nut on shaft tighten 2-3 turns grab drum by sides and pull towards you this should remove drum leaving inner bearing/seal on shaft
5. to replace reverse procedure making sure to pack new bearings w/grease(take drum and use long punch to remove bearing races, use race/seal installer to install new races

1. remove wheel
2. remove caliper/bracket
3. remove rotor
4. remove 4-bolts from behind,tap old hub out
5. reverse procedure

Jeremiah Meyer

• 204 Answers
• Posted on Dec 19, 2008

SOURCE: Where is the thermostat on my 2001 Hyundai Sonata?

Follow the big hose off the radiator and where it ends on the engine is where your thermostat housing and thermostat are. Thanks for using Fixya!

Harry Goodwin

• 353 Answers
• Posted on May 19, 2009

SOURCE: '05 Hyundai Sonata Coolant Change

remove the cap on the radiator or the header tank, use a plastic container that will hold about 4 ltrs of coolant, there should be a drain tap at the bottom of the radiator, if not you have to remove the hose clamp on the bottom hose and let the coolant drain out.
Replace the hose and clamp, top up the radiator and run the motor while checking the coolant level, if the level goes down a bit just top it back up and check over the next day.
hope this helps

PAUL MC G

• 1280 Answers
• Posted on Sep 07, 2009

SOURCE: installing timing belt in 2001 hyundai sonata 6

This should help.

SOURCE: 2000 hyundai sonata auto transmission removal?

Disconnect the battery.remove the front tires.disconnect the lower control arms from the hubs.Remove the axle nuts.Swing away the hub until it clears the end of the drive axle spline.Keep it to the side.Remove the drive axles. remove the starter.remove the torque converter bolts on the flywheel.disconnect the gear linkage and all electrical connectors.disconnect the transmission cooler lines. undo the transmission mounts. use a transmission jack to lower the transmission.Installation is the reverse of the above.Be sure to torque all bolts and nuts to spec,pre load the mounts and replace the cotter pins with new ones.it should take about 5 hours to re and re the transmission.