Where can I found OBD2 in ISUZU 2018 KP34? - Isuzu Cars & Trucks

see
https://www.mycarspecs.com/obd2/isuzu/rodeo/1995/base/p0444-evap-purge-control-valve-circuit-open
not cranking may be a timing belt problem

To check for codes on your car use a good scan tool which plugs into a obd2 port inside the car.

you should be fine with the standard genuine Isuzu tow bar. The rear of the vehicle may be down a bit when fully loaded depending on weight of pop top. weight distribution in pop top is the key. You can fit heavy duty shockers (GAS) & air bags to rear suspension if needed for light vans. They go inside the rear spring coils. The Hayman Reece & sway bars will raise the rear & take weight off of the tow ball but this has not been tested by Isuzu & warranted. Sway bar hitch does not fit on the genuine Isuzu tow bar also. The best thing would be to talk to an Isuzu Dealer such as North East Isuzu Ute at Burton, Adelaide, South Australia to work out your best needs.

Look the codes up at the link please. Complete List of OBD Codes Generic OBD2 OBDII Manufacturer Car OBD...

Go to the link below to look them up. Complete List of OBD Codes Generic OBD2 OBDII Manufacturer Car OBD...

my guess, you are in uSA
with 1995 rodeo. with unstated engine
and wont to use a 1996 scan tool on a 1995 car usa
OBD2 will not work on your 95
the 95 uses custom tools, read $$$$$$$$$$$$$$$$$$$$$$$$$
95 is OBD2
in canada even 97 fails. for obd2 started there in 1998;.

why not say what you are attempting, so we can be on same page.

speaking of pages.
here is the OBD1 flash page

http://www.troublecodes.net/isuzu/

see?

Do not drvie,OBD2 code reader to read codes.coils,module,tune up.

Yes, cell phones do sux. (died mid stream)
please at quesiton? all our 08s are OBD2 certified in USA.
what country?
what car, no car actually stated.?
what symptoms,??
which of many engines is there.
if savvy? what transmission is there, auto or stick.

this is an obd2 trouble code table, it canhelp you understand the meaning of code.
for this code youc can try:

Replace the AIR pump AND one-way check valve

Test and clean the AIR pump AND test and replace the one-way air check valve

Replace the AIR pump inlet hose

Replace the AIR pump fuse (found under the hood)

You must turn the key to "on" for the port to power.

Did you do that?