Question about Cadillac Cars & Trucks
Did you have any codes ? DTC'S - diagnostic trouble codes stored in the PCM/ECM - engine computer . You changed the ACC pedal ?
Posted on Mar 03, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
ok, In this New of a vehicle there are no screws holding the headlight in if you just need to replace a headlight because it is burned out. Look at the back of the light where the wires attach and you should see the wires going into what appears to be a coupling. Get a hold of that and turn. After it unlocks you can remove and replace the bulb. If you are replacing the Headlight assembly because it was damaged there are typically 2 long scews on the top front that appear to be adjsutment screws and 2 smaller ones in each side, again on top. Good Luck
Posted on Aug 27, 2009
The plugs are located by engine head. You can use a ratchet wrench and sockets to remove them. Make sure to mark the plug wires so the order doesn't get mixed up.
The check engine light comes on when there is a bad sensor, or bad circuit.
Many part stores will run an engine diagnostic code scan for free which will pinpoint exact problem that is setting of the check engine light
The light can only be shut off by the diagnostic scanner!!
Posted on Nov 23, 2009
you should have to go thru under the hood to the backside of the lamp assembly. There should be either a hard plastic cap or a plastic dust cover that has the wires going thru it to the lights. If it is the hard cover (looks like a jar cap) turn it 1/4 turn counterclockwise and pull it out of the way. Take the bulb/socket out. Unclip the old one- Put the new one in. (DO NOT TOUCH THE GALSS PART OF NEW BULB). Then re-assemble
Posted on Mar 11, 2010
It holds 7.5 quarts. If you need a copy of your owners manual give me an e-mail address to send it to.
Don't forget to rate this answer.
Posted on Apr 17, 2010
Tips for a great answer:
Feb 24, 2016 | Cadillac Cars & Trucks
Jun 13, 2015 | 2008 Cadillac Dts
The Manifold Absolute Pressure (MAP) Sensor is mounted in the rear of the intake manifold.***** you didn't tell me what motor you have so here are all of them on4.6L&6.0L its mounted in the front of the intake manifold behind the throttle body on the 5.7L its mounted in the rear of the intake manifold
Feb 20, 2015 | 2006 Cadillac DTS
Jul 29, 2011 | 2006 Cadillac DTS
Dec 10, 2010 | 2006 Cadillac DTS
Nov 04, 2010 | 2006 Cadillac DTS
Feb 26, 2010 | 2006 Cadillac DTS
Dec 18, 2009 | 2006 Cadillac DTS
54 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: