SOURCE: R/H rear quarter window repalcement
tv is the wrong adhesive. you must use urethane with a primer. it is available at any QUALITY parts store (NAPA or Carquest comes to mind)
Material
Item
Specification
Urethane Metal Primer Essex U-413
WSB-M2G234-C
Urethane Glass Prep Essex U-401
WSB-M5B280-C
Urethane Glass Primer Essex U-402
WSB-M2G314-B
Urethane Adhesive Essex 400-HV
WSB-M2G316
Removal
All vehicles
WARNING: To prevent glass splinters from entering the eyes or cutting the hands, wear safety glasses and heavy gloves when cutting the glass from the vehicle.
3-Door, 5-Door
NOTE: Some resistance may be encountered when cutting through the glass locating pegs in the lower corners of the glass.
NOTE: Lubricate the existing urethane adhesive with water to aid the special tool while cutting.
Using the special tool, place the flat side of the knife against the quarter glass window. Start at the top and work towards the corners cutting to the given maximum depths:
Wagon
NOTE: Some resistance may be encountered when cutting through the glass locating pegs in the upper right and lower left corners of the glass.
NOTE: Lubricate the existing urethane adhesive with water to aid the special tool while cutting.
Using the special tool, place the flat side of the knife against the quarter glass window. Start at the top and work towards the corners cutting to the given maximum depths:
4-Door
NOTE: Some resistance may be encountered when cutting through the glass locating pegs in the upper right and lower left corners of the glass.
NOTE: Lubricate the existing urethane adhesive with water to aid the special tool while cutting.
Using the special tool, place the flat side of the knife against the quarter glass window. Start at the top and work towards the corners cutting to the given maximum depths:
All vehicles
Installation
CAUTION: When installing urethane installed glass parts, the vehicle must not be driven until the urethane adhesive has cured. At temperatures above 21°C (70°F) and relative humidities above 50%, adequate cure time is typically 24 hours. (Refer to Essex drive away chart for the cure times as temperatures and humidity vary.) Inadequate or incorrect curing can adversely affect the retention of the quarter window glass.
Trim the remaining urethane adhesive. The urethane adhesive must be smooth and free of cuts and contamination after trimming. Avoid touching the urethane adhesive after preparation.
If installing a new rear quarter window glass, apply urethane glass prep twice around the glass surface to be urethaned.
SOURCE: 1999 Toyota Corolla Seca - hatchback. the tail
If you put your foot on the brake, the tail lights and parking lights will still come on. Possibly your brake is sticking. Check to see if it is and if it is put WD40 for a quick fix. See a tech for them to fix your brake alignment. Good Luck!
SOURCE: 1991 Toyota corolla seca won't start
With headlights on, try to start the car.
While engaging the starter: Do the lights dim? Do you hear anything? If so, what do you hear?
SOURCE: How to remove a rear quarter window, that's not a
You have to remove the Rear Panel, then the Window is bolted to teh Manual Window Regulator, Unbold and then pull out at an angle through the SLot
258 views
Usually answered in minutes!
×