SOURCE: peugeot 206 glowplugs
If your not good at mechanicing I suggest you take the car to someone that is experenced.
The reason I say this that we have loads of cars into the workshop with glowpugs broken in the head of the engine with the result of us having to remove the cylinder head.
What happens is that the tip of the glowplug breaks in the head when being removed if it is not done properly.
There is a way that we have found that they can be removed easily without breaking them.
Firsty run the car engine until warm, then we pour a little Diesel fuel onto each plug & let them sit for 15mins or so.
Then we remove them with a deep socket 1/4" drive so we don't put to much pressure on them.
they should screw out easily but we turn them out 1 whole turn then back a 1/4 add a little more diesel ( thimble full) & gently screw them out.
If they start to get really tight screw in again a little then screw out again.
The nuts that hold on the wires just need to be nipped up with a small 8mm spanner, but do not over tighten.
SOURCE: car wont start on 206
you must fill the fuel filter housing with diesel to eliminate air pocket. if you don't have diesel, fill it with automatic transmission fluid. it will smoke for a few seconds, but it will run so fuel pump can catch up. don't touch throttle for a few seconds till you know that it is running on diesel and the tranny fluid is all used up.
SOURCE: I have just bought a peugeot 206 Hdi and the coil light dosn't go
On driver side door sill either on hinges side or lock side check the sticker for tyre pressure. May be your brake light is for your handbrake. Turn the ignition on but don't start the engine put your handbrake down and check wheather light is still on. Is the coil light your are writing is really for glow plugs or radiator ? Better ask peugeot dealer, they don't charge just for asking and it depends on you to take their sky rising costly repairs or just leave.
SOURCE: peugeot 406 hdi electronic immobiliser warning
The ignition key may be defective or in need of a battery to generate the code needed to disarm the immobilizer. Hope this helps!
481 views
Usually answered in minutes!
×