SOURCE: Flasher Relay location- 1998 Mazda B3000 pickup 4x4
it's basically a stand alone relay... most times... look for a relay by itself and often round. my ford winstars flasher relay was actually located in the fuse box under the drivers side dash. it was blue and larger then the other relays so that may be a clue to you.
Robert
Please take a moment to rate this solution
SOURCE: where is the flasher relay located for 1998 Toyota 4- Runner
Toyota Pick-ups, Land Cruiser, and 4 Runner 1997-00
Flashers -REPLACEMENT
The turn signal flasher
is usually located in the convenience center, under the dash, on the
left side kick panel. In all cases, replacement is made by unplugging
the old unit and plugging in a new one.
Hope helped with this (remember rated this help) Good luck.
SOURCE: Where does the flasher go on a 98 chevy malibu
Replacement
The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
Remove the bezel from the ignition switch
Carefully remove the instrument panel accessory trim plate.
To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .
. . . then gently pull the accessory trim plate away
Detach the electrical connector from the hazard warning switch.
Unplug the electrical connector from the hazard warning switch . . .
Unfasten the screw securing the hazard warning switch and remove the switch.
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle
Installation is the reverse of removal.
Testimonial: "just what I needed, thank you so much."
170 views
Usually answered in minutes!
×