SOURCE: need to remove window crank 2004 hyundai accent
Your Local Auto Parts Store has the Tool that you need for this Removal. Some of them will let you Rent it instaed of paying the 50.00 Bucks for the Tool.
SOURCE: Hyundai Tucson
The transmission filter is inside the transmission. You have to drain out the oil and remove the transmission pan and gasket. The filter is made of metal guaze and is screwed/bolted to the underneath of the valve body.
SOURCE: change brakes on a 05 hyundai tucson
rear pad replacement is basically the same as front. 14mm bolts holding caliper and mount on hub then the piston just pushes in
SOURCE: headlight aiming
on each headlamp assembly, there will be either one or two plastic nuts that you can turn.
If you only have one nut on each, that will adjust the vertical aim of the headlights.
If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
SOURCE: i have hyundai tucson 2005.
first obtain a replacement .the cover with tape to prevent shattering the glass then carefully prise of the glass with a screwdriver refitting should be just a case of cleaning any glass away and removing adhesive tape and refitting the glass the heating element is part of the housing and the heat should just transfer through the glass ..not a hard job ..just tricky and time consuming ..if the housing has been damaged .then its a bit more difficult ..first obtain a replacement and then remove the door card then the fixings should be visible remove them and the mirror housing should come loose remove any wiring from the loom then fix the new unit connect any wiring then refit the fixing screws and then replace the door card ..again not the most technical but of work but time taken will show in the end result ..dont loose you temper as it is a bit fiddly ..if in doubt get halford to do it for you or any other similar garage
83 views
Usually answered in minutes!
×