SOURCE: Ignition key won`t turn on my chrysler cirrus
tap the lock cylender with a small hammer it will free up the tumblers and the insert key and its working again.
SOURCE: ignition key won t turn. steering wheel locked
the key may be worn badly or the ignition needs to be replaced.
SOURCE: starter on 2004 chevy trailblazer
When my battery goes dead and the key is in the acc postion then i cant get the key out
SOURCE: 2007 pontiac g5 ignition will turn on the lights
do the lights turn off when you try and start it?
SOURCE: My 2007 tundra went dead. The ignition won't start
There are several possibilities ranging from a defective starter, to bad cable connections, to the onboard security system locking out the starter relay, or an aftermarket accessory interfering with the starter circuit, or a locked-up/damaged engine.
I have had vehicles towed into my shop for similar complaints when the only problem was that the customer was using a cheap duplicate key that they had made at the hardware store that did not have the required computer chip in it.
I have also had vehicles towed in where the customer had replaced the battery and did not have good cable connections or forgot to connect one of the wires that was supposed to to get hooked-up to the battery connector.
Then there are the questions: Are you getting any kind of "clicking" noises when turning the key or is it completely dead? If it is clicking, WHAT is clicking? Is it the starter motor itself that you hear or just the starter motor relay? Do you have battery power at the starter "S" terminal when turning the key? If not, is the transmission selector in "PARK"? Does the shift indicator on the dash indicate that the transmission range sensor is in "PARK"? (possible defective transmission range sensor) Are there any fault codes stored in ANY of the modules connected to your onboard computer network?
It is really hard to say without being able to see the truck.
279 views
Usually answered in minutes!
×