SOURCE: Check Engine Light 1996 Nissan Maxima
The best way is to use a scan tool to clear the codes, that will turn off the light, also disconnecting the battery over night may work, but no completely sure about that, it varies from year to year.
SOURCE: location of a o2 sensor 2001 nissan maxima
bank 1 refers to the side of the engine that #1 cylinder is on , and sensor 2 refers to downstream , after the catalytic converter. , this link shows bank 1 on a 2001 nissan maxima V6 being on the firewall side . if you had a 4 cylinder it would be downstream after the catalytic converter .
http://www.autozone.com/N,26200242/shopping/specsSelect.htm
SOURCE: BMW X5 Trans Fail Safe Program,
sometimes it will clear if you turn the X5 off and restart it. however, it could be an early indication that the tranny is about to expire. i have had it happen and it cleared with a power cycle, but also had friends where it cleared for a few weeks/months and returned. this time it was really the transmission that went bad. if you can't get it to clear, then i'd suggest taking it to the dealer and have them plug into it to have a better look.
SOURCE: 2001 bmw 740il output speed sensor location
hello ryk786, i/m not a hundred percent certain, but I think the output speed sensor is located at the back of the transmission. With the pan removed, if you look at the valve body and see the EDS valves and connectors, look about 2 inches back toward the end of the case and you should see a connector by itself. There should be a retaining torx bolt and spring holding the sensor in place. After installing the new sensor, do not over-tightend the bolt. The torque should be around 5-6 Nm.
SOURCE: where is the trans speed shaft sensor on a 2001 hyundia santa fe?
There are two speed sensors, Input sensor is located on top of the bell house. Output sensor is located on the firewall side of the bell house.
78 views
Usually answered in minutes!
×