Timing marks are often not on the engine but on plastic covers
SOURCE: 2001 chrysler concord 2.7 liter timing set
I have a similar problem. I just replaced the water pump and now the POS wont start. Like it is not getting fuel>
SOURCE: timing marks for cam on 92 camry
on the intake cam use the middle mark in between the big one and the other small one on the exhaust cam use the use the smallest mark farthest away from the 2 small marks on the same tooth. line those 2 marks up on the same tooth in the middle.
SOURCE: replacing timing chain 2000 corolla 1,8 eng
!!! Check first if engine valves are not bended !!!
The timing chain diagram & procedures for 2000 Toyota Corrola 1.8 engine:
Special tools:
1. Crankshaft pulley holder - Tool No. 09213-70010/11.
2. Crankshaft pulley puller - Tool No. 09950-50012.
General precautions:
1. Disconnect battery earth lead.
2. Remove spark plugs to ease turning engine.
3. Turn engine in normal direction of rotation.
4. Observe tightening torques in pictures below.
5. Do NOT turn crankshaft via camshaft or other sprockets.
6. Do NOT turn crankshaft or camshaft with timing chain removed.
7. Mark position of crankshaft position (CKP) sensor before removal.
Valve timing procedures:
1. Ensure crankshaft pulley and timing chain cover TDC marks aligned [1].
2. Ensure teeth timing mark on each camshaft sprocket aligned.
3. 1ZZ-FE/3ZZ-FE/4ZZ-FE [2].
4. 2ZZ-GE [12] OR [13].
5. If not, turn crankshaft pulley 360 degrees.
6. Remove chain tensioner, tensioner rail and chain guide.
7. Check chain for wear.
SOURCE: Fitting n13 timing belt
In Australia the 1990 Nissan N13 engine has a timing BELT not a chain, this could be that the compliance plate reflects the date the vehicle leaves the assembly plant & not the day it was built
166 views
Usually answered in minutes!
×