Question about Volkswagen Jetta
If its a automatic trans it's on top of the transmission final drive housing.
Posted on Feb 22, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
one is located over the battery, the other is located in the side of the dash.
If you pop your hood the battery will be on your right sid in the front of the engine bay. There is a small rectangular piece on top of the battery with a lot of heavy guage red wires going to it. That is the engine bay fuse box.
if you open your driver side car door it's under neath a panel located inbetween the door and the dash board.
Posted on Jun 03, 2009
Either you have a broken wire some where from the speed sensor to the cluster or you have connector at fault, the one which hookup the dash cluster to the main wire bundel. Check the connector, maybe a pushed back pin !!
Posted on Aug 08, 2009
It's located near the cam gear on the front of the engine however, the crank sensor, to the right of the oil filter near the bell housing is the part notorious for going out on these cars, and causing a p0322 and/or p0341 code, and sometimes others as well To replace the crank sensor you have to: Support the motor with a floor jack. Remove the starter, 2 of the starter bolts connect to the motor mount. Remove the motor mount from the frame, very easy. Remove the oil filter. That will give you just enough room to get an allen wrench in to remove the bolt holding the sensor in.
Posted on Oct 25, 2009
SOURCE: need exact location and picture
The exact locations and picture of Engine Coolant Temp (ECT) sensors on 2004 VW Jetta TDI:
1. ECT sensor 1 placed on cylinder head:
2. ECT sensor 2 placed on the left bottom side of the radiator:
Posted on Sep 22, 2010
SOURCE: VW Jetta Crank Postioning Sensor
The crankshaft position sensor is also called engine speed sensor it is located next to the oil filter. it uses one 10mm bolt to hold it on.
Posted on Oct 19, 2010
Tips for a great answer:
Sep 05, 2017 | Volkswagen Jetta Cars & Trucks
Aug 08, 2017 | 2003 Volkswagen Jetta TDI
Dec 30, 2015 | Volkswagen Cars & Trucks
Sep 25, 2014 | 2001 Volkswagen Jetta TDI
Apr 18, 2014 | 2007 Volkswagen Jetta 2.5 Sedan
Apr 18, 2014 | 2002 Volkswagen Jetta TDI
Nov 25, 2012 | Cars & Trucks
Sep 21, 2010 | 2004 Volkswagen Jetta
Jan 10, 2010 | 2007 Volkswagen Jetta 2.5 Sedan
Aug 12, 2009 | 2003 Volkswagen Jetta TDI
27 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: