SOURCE: i think i need to change the crankshaft position sensor.
yes the crankshaft position sensor can cause all these problems at once. they are fairly simple to change and not a really expensive part if you want to check it though you can unplug it and hook a multimeter to it and check ohms as someone cranks the engine. should see a square wave as in 0 ohs to infinity ohms and repeat.
SOURCE: 2004 DODGE STRATUS 2.7L, Location of Crankshaft Position Sensor?
it is located on the right side of the motor, in the trans area. Actually in the bell housing.
SOURCE: where is the crank position sensor located in 2005
Hello martinezmelm: My name is Roger and I can answer your question. To locate the crankshaft position sensor. You will need to remove the timing cover. You will find the sensor on top of the crankshaft gear. Between the V of the timing belt.
Should you need further help please just ask. Please rate the answer as this way I know it was helpful. Thank You for using Fix Ya. Roger
SOURCE: Crankshaft position sensor replacement on 2005 Kia Sedona
The CPS is located under the timming cover 4 small bolts remove the cover and the sensor is viewable 2 bolts have to be loosend and the wire leads up to a dual connector on the left side of the engine
SOURCE: location of crankshaft position sensor on 1999 kia
The crankshaft sensor is in the bell housing,near the flywheel.If this was helpful,please rate,thank you
304 views
Usually answered in minutes!
×