2005 Chrysler Pacifica Logo

Related Topics:

a
anthony quaranta Posted on Feb 21, 2019

2005 Pacifica 60m miles. Just had oil change. Why does oil light turn on while idling at traffic light?

5 Related Answers

hotrodtod38

Todd Bradshaw

  • 141 Answers
  • Posted on Feb 14, 2009

SOURCE: Brake fluid reservoir on a 2005 Chrysler Pacifica

WHEN YOU OPEN YOUR HOOD LOOK DOWN THE DRIVER SIDE FENDER THEN LOOK LEFT ABOUT 10 INCHS AND YOU SOULD FIND IT IT WILL BE WHITE IN THE ENGINE COMPARTMANT AREA

Ad

Anonymous

  • 2 Answers
  • Posted on Mar 08, 2009

SOURCE: Perform Service Light comes on

This is a setting that can be reset to 2000 miles - when it counts down to 0 you get the "Perform Service" alert. I believe if you use the Step function you will see "XX miles to Service" Use the reset button to set this back to 2000.

Anonymous

  • 18 Answers
  • Posted on May 18, 2009

SOURCE: program instruction garage door opener in 2005 chrysler pacifica

if your garage motor have rolling codes you need to put your car inside garage near the motor leave ignition on go to the motor locate learn button press it then quickly go to the car and press and hold one of the buttons for approximately 30 sec or until it start blinking rapidly, if you have a regular motor take one hand held opener go inside car ignition on same time press open button on handheld remote and on the car button 30 sec and it should be programmed.

Anonymous

  • 339 Answers
  • Posted on Aug 16, 2009

SOURCE: the performance service light came on our 2004

Most likely it means that the mechanic didn't bother to reset the service interval after changing the oil.

You can do this yourself by hitting the Step button until you see 0 miles until Service displayed, then hold the reset button until it changes to 3000 miles.

chargerhp

chargerhp

  • 815 Answers
  • Posted on Feb 25, 2010

SOURCE: Need diagram to change oil for a 2005 Chrylser

Drive car on ramps or 2 2x12s reach behind oil pan remove bolt drain hot oil from car that has just been driven.into pan. When oil is just dripping very slow say 15 min replace plug. Now just behind front bumper next to engine is an oil filter remove it with an oil filter wrench. Make sure the gasket came off with the filter or just reach up with a clean rag and wipe the housing it will fall off if you touch it. Put oil on gasket of new filter and screw it on when the gasket touches the housing go 3/4 s of a turn more. Put in about 5-1/2 to6 quarts of 10w 30 oil. Start engine for a min ck for leaks shut off and ck dip stick and make sure it reads full after sitting 5 min or so to let oil dip down into pan

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Reset oil indicated on 05 pacifica

There were 2 directions that I found. Here they are:
  1. With the engine off, turn the ignition switch to "On" without starting the engine.
  2. Within a 10 second interval, push the accelerator pedal all the way down slowly three times within 10 seconds.
  3. Turn the ignition switch to the "LOC" position.
Second one is:

Step 1 Turn the key in your ignition to "ACC." Do not start the engine.
Step 2 Press the "Step" button. This button is located on the instrument panel under the display that tells you how many miles until the car needs to have the oil changed again.
Step 3 Press the "Reset" button until the display shows "3000 Miles to Service."
Turn the key to the "OFF" position and remove it from the ignition. The oil monitoring system has been reset.
Hope this solves your issue.
0helpful
1answer

I have a very small oil leak and my oil light comes on while idle I have a 05 Chrysler Pacifica touring 6 cl 3.5 where should I start

http://www.underhoodservice.com/servicing-the-chrysler-3-5l-engine/

You might take a look at this article.
On a fully warmed up engine at idle, the oil pressure, 5psi min. So says my database.
You might be able to use an analog gage in place of the oil pressure sending unit, to double check oil pressure.
0helpful
1answer

Pacifica oil light

If the oil light is red it means engine oil pressure is below 10psi which can damage the engine. It does not always mean the engine oil level is low.
0helpful
1answer

How do I change the oil pressure switch in a 2004 Chrysler Pacifica

most likely not the sensor; change the oil and use an oil of greater viscosity. which engine? how many miles?
0helpful
1answer

Intermittent Engine Error codes p1009 and p0341.

Bad timing chain tensioner or timing chain has stretched causing cam timing to be off. There is a solenoid for the vtc advancement that also might be bad. Get a good Honda tech to take a look at it!
0helpful
1answer

How do you reset the miles after your car has gotten serviced? I recently got a oil change and the oil light still comes on?


  • Press the "STEP" button until "0 Miles To Service" shows on the screen and then press "RESET" until "3000 Miles To Service"

  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.


Regards, Tony
1helpful
1answer

Hi. i was driving my pacifica and park to order food from drive through and i turn my car off while waiting and as soon i start my car up the car Dinged! And where it has like # of miles to go it said...

I always tell my wife the car is trying to tell her to service me. What this is is a reminder to change your oil and filter and then reset it for the next time.You can reset it to any amount 1000 -6000 anything you want
0helpful
1answer

HI,I HAVE A CHRYSLER PACIFICA 2006 3.5L W SYNTHETIC OIL ,EVERY HOW MANY MILES NEED TO BE CHANGED?

Everyone say's 3000 miles. I was a technician for 16 years, I own three cars. One with 194000, one with 140000 and one with 107000 miles on it. I change my oil every 4000 to 5000 miles. From my experience most engine problems are from a lack of oil, not from a lack of oil changes. Remember to always keep an eye on your oil level.
0helpful
1answer

I have a 2006 pacifica and it has a tick coming from the top side of the motor and the tick increases with acceleration

Hi,

This can often signify lack of lubrication at the top of then engine.

How many miles has the vehicle done, since it's last oil & filter change?
Is the vehicle often parked on an incline?

An oil change may rectify this - I recommend you select your oil carefully.

You can also buy a special oil additive, specifically designed to lubricate the lash adjusters at the top of the engine.


Hope this helps...

5helpful
1answer

The performance service light came on our 2004 Chrysler Pacifica..we got an oil change like 3 wks ago...not sure what this means..

Most likely it means that the mechanic didn't bother to reset the service interval after changing the oil.

You can do this yourself by hitting the Step button until you see 0 miles until Service displayed, then hold the reset button until it changes to 3000 miles.
Not finding what you are looking for?

195 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...