SOURCE: PT Cruiser Brake Light
The bulb in the rear light has burned out and to replace it follow these instructions: 1) go to your owner's manual to find out the part number. You can find and purchase the replacement bulb at Target, any auto parts store and even at Walmart for under $4.00; 2) pop open the trunk door; 3) get a phillips screw driver and unscrew the 2 screws holding the rear brake light fixture to your car body; 4) as soon as you turn over the fixture you'll see where to pull out the burned out bulb and replace it with the new one(s). Good luck!
SOURCE: 2006 PT cruiser Battery warning light !
there is a flash for this probleem available from the dealer per tsb 18-007-07...if that doesnt take care of the problem you may have an issue with the charging system.
SOURCE: 06 pt cruiser dtc p0108,p0113,p0123,and p0508 car will not start
P0108 (M)
Manifold Absolute Pressure/Barometric Pressure Circuit High Input
MAP sensor input above maximum acceptable voltage.
P0113 (M)
Intake Air Temperature Circuit High Input
Intake air (charge) temperature sensor input above the maximum acceptable voltage.
P0508 (M)
Idle Air Control Motor Circuit Low
Idle Air Control Motor Circuit input below acceptable current.
THESE DIFNITIONS ARE FROM THE FACTORY REPAIR MANUAL, LOOKS LIKE YOU MAY HAVE A WIRING HARNESS PROBLEM OR DISCONNECTED COMPONENTS, CHECK THE IAT AND MAP SENSOR AN MAKE SURE THEY ARE CONNECTED.
SOURCE: DIAGNOSTIC code P01A4 for pt cruiser
I have the same problem. Pt - 2002, 2.2 diesel. Same mistake number appeared. Noone knows what is it.
SOURCE: I need a schematic diagram for the radiator fan on
I dont have a diagram, but these have 2 speeds and they are a common problem. the fan will need to be replaced (complete unit)
166 views
Usually answered in minutes!
×