Question about Ford Cars & Trucks

2 Answers

Whith bring new ac compressor , new radiator fan 2008 ford crown vic 4.6l, keep blowing fuse anytime we turn the ac on

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

You simply need a stabalizer for that because when ever the supply volts are down then the requirement of the AC it's need isn't full filled then it gets fuse

Posted on Feb 20, 2019

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 5,066 Answers

What fuse is blowing? I need the fuse number and amp rating, plus, is the fuse in underhood fuse block or interior?

Posted on Feb 20, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

REMiK92
  • 1 Answer

SOURCE: i need a diagram for a 1998 ford crown vic interior fuse box

ITS FUSE #16 AND ITS a 20A FUSE

Posted on Apr 01, 2009

  • 14065 Answers

SOURCE: 2001 crown vic keeps burning 30A PCM relay fuse

have fuel pump checked i have known a bad fuel pump shorting out causing pcm fuse to blow.

Posted on May 10, 2009

emissionwiz
  • 84027 Answers

SOURCE: 2008 Ford F450 fuel pump relay fuse keeps blowing.

the fuel pump and radio are not on the same circuit, most liokely the fuel pump is shorted, that is the most common cause, get under the truck and disconnect the fuel pump connector at the tank, if the fuse doesn't blow then u need a new pump.

Posted on Dec 05, 2009

  • 108 Answers

SOURCE: 2005 Crown Vic climat contr fan not working Fuses good Motor good

does it have a digital control panel? As this uses an electronic blower speed controller located at the engine compartment (rear engine block) fix on ac phlenum try to shake the connector or wire while the system is on.

Posted on Jan 31, 2010

  • 14065 Answers

SOURCE: radiator fan on 03 crown vic runs all the time.

YOUR ENGINE IS GETTING TOO HOT.THERMOSTAT BAD OR RADIATOR CORE CLOGGED AND FRONT GRILLE AIR FLOW BLOCK FROM DEBRIS OR THE COOLING FAN RELAY STUCK CLOSED POSITION MEANING BAD RELAY.

Posted on Apr 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will a bad ac compressor cause my instrument cluster fuse to keep blowing out? I have replaced my fuse twice but for some reason it keeps blowing out and my gages wont work and this problem didn't sta


Sounds like a fuse link by the battery. It is common ground on a Ford or most of them, so they are finicky about the ground. If one is going out, it makes your car go crazy in the electrics. BEWARE though, it can kill you if you have an open circuit. Take this problem to a garage person with diagnostic abilities. It is a lot safer.

Sep 29, 2014 | Cars & Trucks

1 Answer

My 97 ford crown vic. engine will shut off when the ac is turned on what's happening?


With the engine off, key off, try to turn the front part of the AC compressor (not the pulley and belt, but the front part of the clutch). If it cannot be turned, the compressor is seized up and needs to be replaced. If it turns freely (there should be a little resistance, but turn easily by hand), the problem may be electrical- A short in the wiring, or defective engine ECU.

Aug 29, 2014 | 1997 Ford Crown Victoria

1 Answer

Radiator fan always engaged when AC is on


Radiator fan is supposed to blow anytime the A/C is on. Thats how you check to see if a fan is working, cause its supposed to blow anytime the A/C is on , but not neccesarily anytime the engine is running.

Mar 08, 2013 | GMC Envoy Cars & Trucks

1 Answer

'99 Ford Crown Vic LX: #12 30A Maxi fuse blows seconds after starting or ignition turned on.


i had this problem with my 1999 jeep grand cherokee laredo with the brake lights it kept popping fuses right after the ignition was turned on try putting a higher amp fuse in place of the old one that keeps blowing then check for shorts to the starter and check grounds and wires and also the transmission issue check the fluid and then if the fluid is fine change the transmission filter the filter may have not gotten replaced when the transmission was rebuilt and may be clogged or dirty

Oct 04, 2012 | 2002 Ford Crown Victoria

1 Answer

Fuse for AC blower on a 2004 Ford Crown Victoria


fuse loction for blower motor on a 2004 ford crown vic

Jun 19, 2012 | Ford Crown Victoria Cars & Trucks

1 Answer

AC FUSE KEEPS BLOWING ON 1998 FORD CROWN VICTORIA


with out knowing what you have for tools unplug different parts of the system and try another fuse like the compressor clutch the pressure switches and plug them back in one at a time til the fuse blows if you have a ohm meter check to see if any part is shorted to ground

Jun 15, 2012 | 1998 Ford Crown Victoria

1 Answer

When I turn on the heat/AC on my 2000 crown vic my turning signal fuse blows. What could be the problem?


My heat nor turn signals work worked fine then stopped. I have a 91 lx crown Victoria

Sep 23, 2009 | 2000 Ford Crown Victoria

2 Answers

1998 crown victoria compressor doesent work


The clutch itself is the problem (and much cheaper)--replace only the clutch. You might check with a local wrecking yard for such a part. If the compressor was the problem, when the clutch engaged, the drive belt would either break or be thrown off.

Sep 20, 2009 | 1998 Ford Crown Victoria

1 Answer

1997 Crown Vic blows radio fuses


The quickest way to find a short circuit is by putting a bulb in place of the fuse. Anytime the time the bulb lights there is a load. And if the load is a shorted wire the brightness of the bulb will give you a hint. So while you're at it, finding a 'short' is a quicky...keep your eyes on the bulb. gotcha!

Sep 24, 2008 | 1998 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...