Question about Ford Cars & Trucks

1 Answer

2006 ford territory you can be driving along and the gauges drop out you pull over stop the car and restart the car and the gauges are fine

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 929 Answers

Your best bet , take the vehicle to a qualified repair shop an have a full vehicle scan . Do you know what that is ? A qualified repair shop will hook up a professional type scan tool an check for DTC'S - diagnostic trouble codes in all the modules (computers) on the vehicle . The instrument cluster is also a module ,has a microprocessor inside an can also store codes . Someone on here guessing as to the problem could get expensive for you . The instrument cluster could be going bad , lose of communication from the PCM - engine computer , the gauge info comes from the PCM over a serial data network to the instrument cluster . Sensors input data to the PCM an the PCM shares this over the C.A.N - controller area network ,data bus etc...

Posted on Feb 20, 2019


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


SOURCE: Car Stops running while driving

clean the EGR, carbon deposit builds up over time

Posted on Aug 27, 2008

  • 2030 Answers

SOURCE: 2006 Mini Cooper S temperature gauge in red zone

Bad head gasket or cracked head

Btw, I’m available to help over the phone in case u need at

Posted on Feb 10, 2010

  • 2431 Answers


Temperature sensor for the gauge is non op its called temperature sending unit

Posted on Aug 25, 2011

  • 560 Answers

SOURCE: tapping noise from engine renault grand scenic 1.9 dci

sorry scrap it

Posted on Jun 18, 2012

  • 1121 Answers

SOURCE: Car starts fine after sitting awhile. If you drive awhile then stop and try to restart it won't.

Check the electronics,cam sensor or crank sensor these are the culprits.

Posted on Aug 19, 2012

Testimonial: "It was helpful as far as having another idea but we had to take it to the dealer as no one else was able to help. Thank you for your suggestions."

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 ford territory owner manual

i usually look for owner manuals @ givemethedammanual web site

this google dox link doesnt say what year territory

Oct 11, 2016 | 2006 Ford Territory 4.0

1 Answer

A ford territory 2006 that won't start, even after replacing battery?

check for battery voltage at the large terminal on the starter. THere should be power at all times.

Have a helper turn the key to the crank position while you check for power on the smaller wire at the starter. There should be power anytime the key is in the crank position.

If there is power at both terminals than the starter is bad. If there is no power at the large wire check your battery connection. If there is no power at the the small wire you will need to trace it back to its origin.

I’m happy to assist further over the phone at

Oct 08, 2016 | 2006 Ford Territory 4.0

1 Answer

2006 Territory rough in idling when in Drive when foot on brake Pedal,out off drive Engine idling perfect.In reverse no proplem either.Please advice how to fix.

You may have engine mounts that defective or a grounded exhaust system causing the vibration. Before you do anything have a dealer look at this issue.

Jun 18, 2016 | 2006 Ford Territory 4.0

1 Answer

What is optimal water temperature for a Territory?

I am not sure what units are on the gage. The engine should be running at 195 degrees farenheite

Mar 31, 2014 | 2006 Ford Territory 4.0

1 Answer

Fuel gauge not working on territory

the fuel censor is not working and you can also locate the exact problem with the help of repair manual but if do not have the manual then you can go the given link from where you will get the manual easily

Dec 28, 2013 | 2006 Ford Territory 4.0

1 Answer

Replace fog light globe on 2006 ford territory

To get at the fog lights out you have to unclip them, 4 latches - one on each cnr of the black ousing which can be reached by reaching down past headlights.
Once loose they can be accessed by removing the wheel arch lining and pull out that way after unclipping the wiring block connnector. They look like a sealed unit but are not and come apart between the ehite and black housing. This makes it possible to be able to replace the 55w halogen bulb

Oct 23, 2013 | 2006 Ford Territory 4.0

1 Answer

Aircon fuse blows with ford territory toward

replace it with a bigger fuss type if its 20 use a 25 or 30 until this issue stops

Jul 31, 2012 | 2006 Ford Territory 4.0

1 Answer

2006 Mini Cooper S temperature gauge in red zone

Bad head gasket or cracked head

Btw, I’m available to help over the phone in case u need at

Feb 10, 2010 | 2006 Mini Cooper

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides