Question about Hyundai Cars & Trucks

1 Answer

I am replacing my lash adjusters on my 2001 Hyundai Accent 1.5. do I need to prime them or should I just put them all in and be on the go.?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 25 Answers

If you replaced the lifters it would not be a bad idea to soak them in oil before putting them in but if it was just the adjusters you won't need to but if it is not a pretty set rail that your adjusters are on you will need to adjust them correctly. First why did you think you needed to replace them .

Posted on Feb 19, 2019

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1757 Answers

SOURCE: timing belt on huyndai accent 2001

My sincere apologies for the severly delayed response.
I am personally going back to answer your unanswered questions. I have only been on this site for the past 4-months as a free contributor.

I do not know if you still need this information, however I am answering it - in case you still do.

Click on the following direct Link. It has several Diagrams for your 2001 Hyundai Accent Timing Belt and Marks.


Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!


http://www.2carpros.com/car_repair_information/year/2001/make/hyundai/model/accent/2001_hyundai_accent_timing_belt_diagram_marks.htm

Posted on Mar 19, 2010

johnjnail
  • 1702 Answers

SOURCE: what is the valve lash

automatic valve lash adjusters are used in the 1.5L valve clearance is not adjustable.

Posted on Jan 29, 2011

  • 3519 Answers

SOURCE: 2001 Hyundai accent wouldn't start this morning after sitting two days prime and no codes kept screwing with it I primed and runs then only primes sometimes but still runs great miss chug

Hi Miss Chug:
I'd start by using some carb/injector cleaner and make sure that the fuel delivery system is working properly.
If this is a carb type engine, make sure the automatic choke is not sticking.

Posted on Jun 30, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I arrange my spark plug wires on my Hyundai Getz go 2002


How to change spark plugs hyundai accent 01 - 05 - YouTube

? 3:18
https://www.youtube.com/watch?v=tU2vwisJ7v4
Feb 16, 2012 - Uploaded by PNBNC
I filmed this right after changing my old plugs, I figured it was easy enough to film and some people can profit from it. for a ... Coil, you mean wire lol ... When you go to put the spark plug back in, never start it with the ratchet.

How To Replace Change Install Spark Plugs 2001-06 ...

? 3:17
https://www.youtube.com/watch?v=yVV2KcPDFIo
May 14, 2013 - Uploaded by 1A Auto Parts
... spark plugs. This video is applicable to the 2001, 2002, 2... ...spark plugs. This video is applicable to the 2001, 2002, 2003, 2004, 2005, 2006 Hyundai Elantra 2.0L. ... +queentonks A little know-how can go a long way. We're glad ... When do you think is good to replace my spark plugs wires? My spark ...
2001 Hyundai Accent Firing Order: Engine Mechanical ...www.2carpros.com/.../hyundai-accent-2001-hyundai-accent-firing-orderApr 23, 2009 - Engine Mechanical problem 2001 Hyundai Accent 4 cyl Two Wheel Drive Manual 95000 ... Now I'm trying to figure out how they go back on. How do I find out the Engine Firing Order for my car - Hyundai Accent 2001 1.5L?Which is cylinder 1 - 1.6 Accent - Hyundai Forum: Hyundai ...www.hyundaiperformance.com/.../16837-cylinder-1-1-6-accent.htmlJan 13, 2003 - 3 posts - ‎3 authorsFrom what I read though, the coil pack is configured as 1 4 2 3. I'm assuming the first wire on the coil pack goes to cylinder 1. Can anyone ...

Dec 16, 2015 | Hyundai Cars & Trucks

1 Answer

2001 Hyundai accent wouldn't start this morning after sitting two days prime and no codes kept screwing with it I primed and runs then only primes sometimes but still runs great miss chug


Hi Miss Chug:
I'd start by using some carb/injector cleaner and make sure that the fuel delivery system is working properly.
If this is a carb type engine, make sure the automatic choke is not sticking.

Jun 30, 2015 | Hyundai Cars & Trucks

1 Answer

Where can I find the back brake adjustment wheel on a 2001 hyundai accent


look for a small slot in the top of the backing plate ( plugged up with a rubber block). Inside there will be small notched wheel that screws a threaded bar . Because of the conditions of the backing plate some manufacturers put the hole in the drum behind the wheel meaning the wheel has to be removed first.

Jul 27, 2014 | 2001 Hyundai Accent

1 Answer

How do I adjust the rear drum brakes on a 2001 Hyundai Accent?


To get a "ball-Park" adjustment, just turn the adjustment mechanism (with drum removed) 'till you can just put the drum back on and it turns without binding. Your self-adjusters will finish the job for you as you drive. Worst thing you can do is set initial adjustment too tight as that will burn the shoes before they get a chance to properly break in. Doing it how I said, will avoid that.

May 26, 2011 | 2001 Hyundai Accent

1 Answer

What is the valve lash adjustment for a 2001 hyundai Accent L 1.5 liter?


automatic valve lash adjusters are used in the 1.5L valve clearance is not adjustable.

Jan 29, 2011 | Hyundai Accent Cars & Trucks

1 Answer

Trying to adjust clutch on 2001 Hyundai Accent.


hydraulic clutches are non-adjustable

Oct 14, 2009 | 2001 Hyundai Accent

1 Answer

Valve adjustment


tiburon uses hydrolic lash adjusters there are no valve lash adjusting If you hearing a pecking sound on the top of the mtr try some oil additive or replace the hydrolic lash adjusters

Jun 15, 2009 | 2001 Mitsubishi Eclipse

1 Answer

To change gears, I need to fully press down on my clutch pedal to stop a grinding noise on my hyundai accent 2001Can I adjust the clutch cable,


Hi and welcome to FixYa,

In a manual 2001 Hyundai Accent, the clutch cable could be adjusted. The adjustment point is on the cable 'pad' where it enters the firewall in the engine compartment.
86c2d7d.jpg
To adjust, the slack or free play must be decreased. This is done by turning the adjusting nut clockwise. Check back by pressing on the clutch pedal to your preference.
73309c3.jpg
Good luck and thank you for using FixYa.

Feb 18, 2009 | Hyundai Motor 1995 Accent

5 Answers

I have a 2001 hyundai accent. How much oil does it require ?


it should tell you on the cap of the oil what oil and start with 4 qrt and then let sit for a few minutes then chec dipstick usauly its 5 qrts

Jan 25, 2009 | 2001 Hyundai Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Jonah Oneal

Level 3 Expert

14065 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...