SOURCE: 1999 volvo v70 oil change questions
You can buy a canister wrench at the local auto parts store. You do not need to torque the oil filter on, just hand tighten, No new gasket for the drain plugs just do make sure that it is tightened properly
SOURCE: I need the torque specs and sequence on a 1998 chevy 350 vortec
Vortecs are a little different that old school small blocks, grab a Haynes or Chiltons, the cross patterns and specs are simply diagramed. Vortec, as any really, start with 25# then 45# and then final torque which I believe is around 70-75# but to be sure verify with the manual. AutoZones, Murry's, Adavance auto all carry the books, Cheap insurance.
Dan
Gasket = $35 (permatex rubber)
Labor - my manual says 3 hours.
You'll have to be responsible for figuring out the labor price per hour depending on where you are located.
In MI, a garage is about $50/hr, and dealership = $85/hr
CA might be $95/$150/hr.
Parts are minimal on the job - its all labor.
Figure in about $20 for shop supplies... gasket remover, sealant, rags, etc.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: i need bolt torque specs for a 2006 chevy cobalt
if you just go to a mecanic and ask what are the specks on that they should know but i think if you just tighten them down with an impact wrench till it is really tight after ou start the car it will run like **** then it will work its self out
SOURCE: Hi, I have a 2006 chevy aveo and I was recently
Its easy. I did mine about a month ago. You need to take off all the bolts on the top part of the motor. there are some tubes on the left side of the motor by pushing them out of the way... you take the old one off and replace it with the new one making sure its aligned and the you put it back on.. the bolts need to be hand tightened kinda as tight as you would do your tires.
114 views
Usually answered in minutes!
×