1993 Isuzu Trooper Logo

Related Topics:

Timing marks on a sohc v6 isuzu engine

I have a 1993 Isuzu trooper v6 SOHC I am looking for a good picture of the timing marks for replacing timing belt

5 Related Answers

Anonymous

  • 740 Answers
  • Posted on Dec 20, 2008

SOURCE: timing marks needed for '91 1.6L SOHC

Here is your diagram, Please leave me a FI YA comment if I fixed ya thanks http://www.2carpros.com/car_repair_information/tec_info/1998/eagle/talon/1998_eagle_talon_timing_belt_diagram_marks.htm

Ad

Anonymous

  • 152 Answers
  • Posted on Jan 01, 2009

SOURCE: oil pressure sensor location

drivers side right above the oil pan

kel1guy2002

Kelly

  • 3740 Answers
  • Posted on Jan 20, 2010

SOURCE: How to clean EGR valve passages in 1993 Isuzu Trooper DOHC V6

You have to the EGR valve (sometimes the Intake manifold to EGR Vlalve line also). After you remove it take a drill bit the about 20 % smaller than the actual hole of the outlet side and rotate the drill bit with your hand to dig out the carbon. Aditionally the line coming from the intake manifold to the EGR valve will clog near the connection to the EGR valve. I use either a single piece of copper wire or the wire that you would use to tie ribar together to clean the line. When your done cleaning take a piece of vacuum line and connect it to the diaphram side and **** on it... then plug the line well with your thumb. Grasp the valve and blow thru it... Air should blow thru it freely. Remove your thumb from the vacuum line and try blowing again.. No air should pass thru the valve.
Then reinstall the valve and start the vehicle with the vacuum line disconnected (but blocked off) Use another piece of vacuum line connected to the diaphram again and **** on the line.. The vehicle should die or run really bad. If it does this then you cleaned it correctly.

Patrick Rayome

  • 1757 Answers
  • Posted on Mar 25, 2010

SOURCE: isuzu trooper 2002 RLV engine. camshaft timing

Sorry for the severe delay.
I am personally going back to answer your unanswered question.
I do not know if you still need the answer, but I am going to answer it in case you still do.

Click on the following direct Link. It has the Timing Belt Diagrams and Photos with Marks for the Camshaft and Crankshaft that you will need. It also has numerous other helpful diagrams, instructions and photo's for use.

Again my apologies...
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!


http://www.2carpros.com/car_repair_information/year/2002/make/isuzu/model/trooper/2002_isuzu_trooper_timing_belt_diagram_marks.htm

Anonymous

  • 642 Answers
  • Posted on May 30, 2010

SOURCE: 1999 Trooper: steps in replacing timing belt on 1999 isuzu troop...

I also did a small write-up but this is much better.
http://www.2carpros.com/car_repair_information/year/1999/make/isuzu/model/trooper/1999_isuzu_trooper_timing_belt_diagram_marks.htm

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to install isuzu kb 350 camshaft and do the timing

do not guess timing on any engines, or risk valve damage.
the service manual covers all this.
no year car told or country , (an Iisuzu FASTER class truck)
KB350 , is in Africa or Down Under? guess it is 3.5L V6 (gm?)
Just so you know, the books are by country , maker ,model , year and chapters on the engine option there.
we have no KB in the USA ,not one.
it broke the the cam belt or stripped it out my guess.
seems too you bent over valves.
which engine is there or "wiki isuzu engines" and find it and tell it first.
or buy the shop manual from Isuzu.
The 2006 up is GM and is Interference engine and now damaged,
is this post a bingo,, ?????? there are 2 types 3.5L,

may be wrong there is no African wiki for KB350 or for any Australian bakkie ether, so facts super hard to find, not living there.

just this but I think is 1999 ISUZU TROOPER
https://www.fixya.com/cars/t15182528-isuzu_kb_350_v6_cam_timing_settings

I bet a by hand , keys in pocket only fails a leak down test.
cylinder leak down tool (common and nails here)
cranked by hand only, gently. (no need to bend valves more)
i think your 3.5L is SOHC or DOHC cam with belt drive cams.
KB was sold in AUSTRIALIA BUT NO 3.5l
SO AFRICA KB , 2013?
OUR OLD TROOPER HAD 3.5 SOHC.
6VD1 SOLD SOHC AND DOHC VERSIONS BOTH.
OR 6VE1-W 3.5L DOHC 24V V6 was introduced in 1998
AND SOME TO AFRICA ARE GM ENGINES.
SORRY CAN'T GUESS YOURS THE WIKI IS (VACUUM HERE)
0helpful
1answer

Firing order 1994 iszuzu trooper 3,2 sohc

its a V6
Order: 1-2-3-4-5-6 Distributorless Ignition System
outside usa , ive not a clue.
and i bet you are.

3,2, tells me (not USA) comma for decimals.was the clue.

EFI systems vary world wide)
the firing order on ours is per above, im not sure how many 3.2v6 are made world wide, with different crank /cams.
seems there are 3 if you read the wiki......

there is a gm v6 LG6 is 3.1L and isuzu v6 (x2) 3.2L
the real Isuzu is called 6VD1 engine
later years GM 4.3L
my guess is 6VD1 or W

and 6VD1W. twin cam. introduced in 1996 on troopers.

76 degree V 6's
per the wiki
The feature either a belt-driven SOHC or DOHC valvetrain. Later versions feature direct ignition as well as gasoline direct injection. These engines are notable for their early adoption of gasoline direct injection technology and also for their uncommon 75° cylinder head bank angle.


before i work on and engine i learn what is there first.
as you can see wide variances there are.
post country first. then if single or twin cams.

but the firing order is dictated by cam and crank geometries.
0helpful
1answer

How removed water pomp isussu trooper 94. 3.2

there are two 3.2L
3.2 L 6VD1 SOHC V6
3.2 L 6VD1 DOHC V6
which one. (open hood look up, see EPA sticker, it tells you.
as does cam count.

0helpful
1answer

Torque tightening isuzu trooper 3.2 sohc

graphic.aspx?mod=reptiff&module_id=1&session_id=%7bf56598c0-a9c2-4934-abd5-a04190f031ee%7d&image_guid=94e46833&print_bw=0&m bolts15 foot lb 11mm bolts 47 foot lbs
1helpful
1answer

Proper spar plug wiring for 1994 Isuzu trooper

2 different engines. Both 3.2 liter but one is a SOHC and the othe a DOHC. I gave you pictures for both. I hope this helps and good luck.


clifford224_189.jpgclifford224_190.jpg
13helpful
2answers

I need a diagram to sincronize the timing belt of my isuzu tropper 3.2 sohc

if this is 6VD1 engine it has single cam gear each head, but is still a 2 cams per head, engine
if belt has broke or you have turned any gear you must remove rocker covers to check positions of camshafts front lobes are in certain spot as well as timming mark on belt driven cam gear to cover
this cam gear is a 3:1 ratio (3 turns of cam gear = 1 turn of cams)
184d763.jpg
0helpful
1answer

I have a 1993 isuzu pick up newly built need schematics on firing order and distributor rotor location and timing marks and timing belt replacement any help will be thankfull

1993 Isuzu Pickup 2WD
2.3 liter SOHC L4

05fbccb.gif
1993 Isuzu Pickup 2WD
2.6 liter SOHC L4 .......same as above


1993 Isuzu Pickup 2WD
3.1 liter V-6

3287635.gif
4wd is the same specs as the 2wd.
Not finding what you are looking for?

487 views

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...