Would like to know which wires go where on my 1991 l200 4g54 coil please

post 2 of 3
im only answering to post 1 now.

the wires that come from the ignition go on the + terminal of the coil. As most earth wires are plain black I would say the white wire to the + terminal and the black to the distributor

Are you getting power to the coil from the ignition switch? Use a 12 volt test light with the clip attached to engine ground. Turn the key on and backprobe the connector terminal with the black wire/red stripe. If there is no power to the coil, trace the wire back to the ignition switch to see if it is broken, or replace the ignition switch.
If there is power to the coil, open the distributor and check the components there for excessive wear or broken wires on the pickup coil.
Please let me know if you have more questions.

neg wire on coil

there are four screws that u push down on and turn counter clockwise as you push down, they hook under the distributor, then disconnect the wiring harness and pull the cap off

it should be the white wire going from the distributer to the coil.

As Long As You Have No Spark, Or Fuel, Replace Ignition Module. In Might Be The Pick-Up In The Distributor, Which Means A Whole New Dist. You Can Get And Dist. With Module. Good Luck

I HAVE A QUESTION THAT MIGHT HELP, THE 22-RE 4 CYLINDER HAS A STEEL TIMING CHAIN, IVE BEEN TOLD THAT THE V-6 HAS A RUBBER TIMING BELT ON THE SIDE OF THE MOTOR UNDER A COVER?

found a good repair manual and followed the wiring diagram ~~~ Thank You / Jeff