Question about Audi Cars & Trucks

1 Answer

I find water on the driver side floor of my audi 2012 A4 B 8..now the headlights won't go off itc shows a headlights malfunction fault and brak pads..which just replaced recently. no leaving home lights. it also ahows headlamp converter fault..what could be thr problem

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Dedicated:

    Visited the website for 20 consecutive days.

  • Audi Master
  • 446 Answers

The service and repair manual will help you with diagram to locate and fix the problem step by step and you will get the manual from the given link https://toolsnyou.com

Posted on Feb 16, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
techbuster
  • 5081 Answers

SOURCE: How do you replace the drivers side headlight bulb

1. Remove headlight housing. A.Open Hood and pull the release lever at the back of the housing. The headlight housing slides in and out of the body in tracks. B.Pull out the headlight housing far enough to disconnect the electric connectors, then slide the housing completely out. 2. Remove the retaining clip to remove the upper (low beam) or lower (high beam) bulb from the holder from the back of the housing unit. Remove the old bulb(s). 3. Do not touch the bulb with your bare hands! Wear clean gloves or hold with a clean paper towel. Fingerprints on the bulb will cause the bulb to burn out or explode!. Insert the new bulb. 4. Replace the retaining clips and insert the housing back into the tracks and into the body. Plug the electric connectors in and insert the housing completely. 5. Reposition the release lever to the original position being careful not to break the plasic lever. 6. Check your lights for operation.

Posted on Nov 01, 2009

moparownr
  • 667 Answers

SOURCE: Have a leak in my Mustang 2003 convertable.

I have had this problem before, remove the inner trim panel on the rear look down at the bottom of the fender well there is a drain hole there, it is probably plugged up, it is there to drain rain water out of the car that comes in when it rains. Hope this helps, let me know.

Posted on Nov 19, 2009

  • 163 Answers

SOURCE: Replace pass side headlight bulb on Volvo '02 S40

won`t the coolent tube pull out

Posted on Nov 28, 2009

  • 1 Answer

SOURCE: 2004 Audi A4 headlight replacement

you have to loosen the whole headlight assembly to open the covers behind the lights to actually get to the bulbs. 4 screws, 2 are on the top of the assembly(phillips screws) the other two are hex and attach the bottom of the assembly to the car. somewhat difficult to see but look behind the assembly and down into the compartment and loosen the screws(they don't fully come out) just enough to pull the assembly out. open the black cover behind he low bean and there is the bulb

Posted on Feb 05, 2010

  • 237 Answers

SOURCE: 2006 Nissan Altima LH driver

you will find another fuse block under hood near windshield washer fill neck.remove the cover and it will show the location of headlamp fuses.most likely is a blown fuse.

Posted on Feb 20, 2011

Testimonial: "Thanks...I was looking inside the cover for a diagram, only to notice it was on the outside of the cover after removing the dirt. Fuse was bad."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

How to adjust AUDI headlights beams


There are two adjustment points (screws). For example left headlight: you will see one point near the end of left wing, at bottom side through a wing hole. This is for vertical plane headlight beam adjustment (up-down). Another one point is against water radiator side. This is for horizontal plane headlight beam adjustment (left-right).

on Dec 18, 2009 | Audi A4 Cars & Trucks

1 Answer

My car is an audi a4 everytime i start the engine the symbol for dynamic headlights range control shows up, how can i reset it?


You need to repair the fault....usually caused by a defective suspension height sensor or headlight adjustment motor.

Feb 19, 2015 | 2004 Audi A4

2 Answers

98 camry leaks coolant on driver side floor defroster won't work


your heater core is at fault,to replace dash has to come partially apart

Oct 17, 2012 | 1998 Toyota Camry

1 Answer

I have a serious water leak on the driver side front of my 2004 Audi A4 1.9tdi se. I have checked the drain plugs under the battery and servo and both are clear. Where else can the water get in? its only...


Take a look under the car and make sure the floor plugs didnt fall out or theres a hole in the floor board, the only other thing is the windsheild, have you had a replacement install, maybe its leaking from there.and if you have a sun roof make sure the drains on the sides are clear and not plugged, good luck, have a nice day.

Jan 08, 2011 | 2004 Audi A4

1 Answer

How to remove headlamp drivers side on audi a6 2001


Hi

Here is a video on youtube showing how to remove the headlight, if this one is not the correct model then search through the others at the side they are evry helpful regards
Dan http://www.youtube.com/watch?v=BtTpDq_Wy_c

Jan 02, 2011 | 2001 Audi A6

1 Answer

I Have an Audi a4 Quatro 2004 model. Adjust Low Beams?


There are two adjustment points (screws). For example left headlight: you will see one point near the end of left wing, at bottom side through a wing hole. This is for vertical plane headlight beam adjustment (up-down). Another one point is against water radiator side. This is for horizontal plane headlight beam adjustment (left-right).

Nov 19, 2009 | 2004 Audi A4

2 Answers

Driver's side headlights don't work, although indicators do!


The most common fault is ground use a test light at the plug it should show you what is missing. Most garages should be able to hande it in about an hour.

Aug 02, 2009 | 2000 Ford Focus

1 Answer

What size bulb is an audi s4 headlight and fog light?


SYLVANIA H7 SILVERSTAR HIGH PERFORMANCE HALOGEN HEADLIGHT BULB -- 55 Watts, Single C-8 filament for use as either high beam or low beam; 100 percent legal halogen headlight bulbs; Features the whitest and brightest light colour similar to daylight for safer night driving; Meets all US FMVSS 108 and Canadian CMVSS 108 requirements. Fits Driver or Passenger Side Driver or Passenger Side Fits the following vehicle/s
2004 Audi S4 Base 8 Cyl 4.2L 2004: Base; 8 Cyl 4.2L RAMPAGE FOG LIGHT, BLACK METAL HOUSING, With round clear lens; Includes 100-Watt H3 halogen bulb, one lamp and a single bolt mounting system; Provides better illumination Fog Light

  • Fits the following vehicle/s: 2004 Audi S4 Base 8 Cyl 4.2L 2004: Base; 8 Cyl 4.2L;

Jun 24, 2009 | 2004 Audi S4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Marvin
Marvin

Level 3 Expert

84027 Answers

Jonah Oneal

Level 3 Expert

14059 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...