Question about Chevrolet Metro

1 Answer

98 Chevy metro regular headlights don't work but high beams do, suggestions?

The metro has working high beams and running (fog) lights work, but regular headlights do not. Both lights suddenly stopped working. Suggestions where to start.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,815 Answers

I have seen both low beam bulbs burn out at the same time.
Its possible the relays have burnt out for the low beams.

Posted on Feb 16, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1311 Answers

SOURCE: All of a sudden both my low beam headlights are

Replace Relay #46 in underhood fuse panel.

Posted on Oct 01, 2010

  • 11 Answers

SOURCE: all interior and exterior lights work except headlights...

BAD HEADLIGHT CONTROL SWITCH,REPLACE IT BEFORE IT MELTS YOUR DASH,THEY GET VERY HOT WHEN THEY FAIL

Posted on Dec 20, 2008

SOURCE: low beam headlights stopped working simutaneously

Check and replace the fuses where needed.

Posted on Nov 28, 2008

  • 193 Answers

SOURCE: high beams wont turn on.

First place to start is with headlight switch. I did have a case many years ago when both high beams were blown out at once, but this is rare. When you have the headlight switch out, jump power from te low beams to the high beam contacts. If high beams come on, replace switch.
Bill

Posted on Nov 19, 2008

DickCanFixIt
  • 948 Answers

SOURCE: Headlights don't work on start up

Energy must pass through your switch (hi/low or momentary), then to your headlight, and finally to ground. An interruption anywhere will cause the light to go out. Since both your hi and low beams are not working, I suspect a bad ground connection somewhere. Probably in your switch, but if it is easier to check the headlight socket I would check that too. Use a multi-meter, see if you have power to the switch. If you do, ground the negative lead coming to the switch and see if your headlight comes on. If it does, you know you have a bad ground.

Posted on May 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No highbeams low works fine. changed switch but still the same fuses are good. help


98 Explorer No High Beams Problem - Ford Explorer and Ranger ...

https://www.explorerforum.com/forums/showthread.php?t=374129

Nov 15, 2012 - 16 posts - ‎8 authors
98 Explorer XLT 4X4 - No high beams. I've read thru many threads here and other places about this. Pulled and checked every fuse - all good ... Fog Lights Off When High Beams Activated - Normal?
19 posts
Nov 30, 2015
Headlights not working (not MFS, Fuses, or bulbs)
12 posts
Feb 24, 2015
97 explorer no low beams high beams
3 posts
Nov 4, 2013
no headlights in 96
15 posts
May 7, 2009
More results from www.explorerforum.com

Jan 03, 2016 | 1998 Ford Explorer

1 Answer

Low beams not working but high beams are on a 2000 chevy metro


The headlight relay provides power to the dimmer relay, then power goes thru a fuse for each light for each circuit (4). The low beam fuses are in fuse block 2. The dimmer relay is controlled by the daytime running light module. The headlight and dimmer switches send signals to the DRL module. You may need a shop manual to troubleshoot the circuits.

Jan 24, 2014 | 2000 Chevrolet Metro

1 Answer

Is my 2007 Lincoln Navigator (HID headlights) equipped with HIGH BEAMS? If so - they don't seem to work. Allow me to explain; 1. The headlights come on automatically in low light conditions. 2. The...


First of all are your headlights a double filament type headlight? If yes then I would suspect that a power wire to the high beams is broken or shorted. If your high beams are a separate set of lights from your regulars running lights then either the high beams headlights are missing. or has a broken power wire or shorted or...You could check the fuse box under your dash and under the hood of the car to see if you have a fuse for the high beam lights.

Oct 28, 2013 | Cars & Trucks

1 Answer

High beam indicator comes on with fog lights


Could your Mazda have daytime running lights? If you checked all fuses, did that include the three in the joint box?

There is an auto light-off control module that is central to all functions you describe. It is assumed that you would only turn on the fog lights with headlights on and set for high beam. If you set the headlight switch to LOW, the module closes the headlight relay to turn on the low beams. If you then turn the headlight switch to HIGH, the module turns on the high beams and allows you to turn on the FOG LIGHT switch, closing the fog light relay and turning on the fog lights. Since this sequence is not working, I suggest checking both high beam lamps as both could be burned out. Other possibilities are a defective headlight switch or the module

Oct 01, 2012 | 2005 Mazda 6

2 Answers

2005 Ford Focus ZX3 SES, the blue high beam indicator in the dash comes on with low beams, and goes off with high beams. The indicator is on at the wrong time! I have tried the following: The turn signal...


It sounds like you are confused about how your headlamp system is supposed to work. The DRL does not run on the High beam circuit, it runs on the low beam circuit. The fog lamps are supposed operate with the park lamps and also with the low beams, not the high beams. From your description, I would say that your system is operating as designed and you are having trouble telling High from Low. (Don't feel bad, that is why high beam indicators were invented in the first place.)

May 08, 2011 | 2005 Ford Focus

2 Answers

Hi I have a 1997 for f150 I have no high or low head lights


check the fuses first, no luck replace the day time running light module.

Jan 27, 2010 | 1997 Ford F150 Regular Cab

4 Answers

Daytime running lights work but go out when I turn headlights on. Ruled out headlight switch, bulbs, fuses, relay, ground, and DRL module. 98 silverado 1500 has no high beams. headlights work with parking...


If you have daytime running lights but when you turn on your regular headlight on they do not come on. Take the bottom of your steering column off (Two Small Screws) and look at the back of your turn/dimmer switch make sure that the light blue wire is connected. The wires will break off after years of raising and lowering your steering column.

Jun 03, 2009 | 2000 Chevrolet Blazer

1 Answer

No headlights


try checking the relay on the headlamps

Aug 25, 2008 | 1997 Geo Metro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Jonah Oneal

Level 3 Expert

14059 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...