SOURCE: Mark lt starter
disconnect batt,remove the 3 starter mounting bolts and ground cable(should be connected to one of the mounting bolts),disconnect the 2 wires on the starter.install new starter and then reconnect batt.
SOURCE: I have a 2006 lincoln mark lt that has a check engine code VSS
no i dont think so more than likely its the sensor on the speedo drive
SOURCE: 2007 Lincoln Mark LT Key Fob
Theres only 1 way to tell if it will work - try it :)
Here is the procedure to marry a new remote to your truck.
1. Close all doors and then open drivers door and press
the UNLOCK
button on drivers door panel while door is open and insert
key in ignition.
2. Turn ignition
from OFF to RUN (not start) 8 times within 10 seconds, with the
8th time ending
in RUN. Door locks will cycle to confirm programming
mode.
3. Within 20 seconds press any button on first keyless
remote.
Door locks will cycle to confirm
programming.
4. Within 20 seconds, press any button on second keyless
remote.
Door locks will cycle again to confirm
programming.
5. Turn ignition to OFF.
Locks will again cycle
to indicate end of programming mode.
Both the Escape and LT program the same - the transponder should have the same resistance.
Try it out!!
Thanks for using FixYa - a Very Helpful Rating is appreciated for answering your FREE question.
SOURCE: ball joint is squeaking at
YOU NEED SPECIAL TOOLS TO DO THE JOB. BEST TO LET A GARAGE FIX IT THAT WORKS ON FRONT AND REAR SUSPENSION SYSTEMS.
SOURCE: How do I change the
For the new body style 2004 ( not the 2004 Heritage or lightning ) there are 3 bolts to remove, and 1 tab, and the headlamp unit pulls out form the front.
From the owners manual
If you did not get an owners manual with your truck ( purchased used ), you can download one from Ford :
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp
278 views
Usually answered in minutes!
×