How do i remove and replace dashboard in 2005 dodge magnum?

SOURCE: 2005 Dodge Magnum w/out hemi stalling

I have a 2005 Magnum and was also having this problem. Stalled out a few times and continued to idle rough and feel like it was going to die when I would slow down. At times it would feel like I would get a hesitation and then a surge. Engine light would go on for a day or so, then go out for a few days. First time I took it in, the dealership told me that it was a broken seal (I don't know where), but they replaced it and it continued to happen. The second time I took it to a mom & pop shop, and they told me that it was the oxygen sensor/altimeter, replaced it (only a $35 part), and I haven't had a problem since. That was 6 months ago. Hope this helps...

SOURCE: 2005 Dodge Magnum, after replacing battery,cd player won't work

My story Dealing with Dodge

I had a 1994 Dodge Ram. The Red Dodge Ram I had it malfunctioned and my brake became the throttle. I had to put the truck in reverse then park. to stop, after it was out of control at 80 mph a hill slowed us down. Are you sure its not electrical and the curse control is not giving you trouble? Mine had multifunction switch was not working and the headlight switch burned up. I also found out that Audi had problem with the brake becoming the throttle in the 1980s Daimler Chrysler and Audi were German made. I don't think there is an easy answer. I hope you stay safe. Another man is having strange trouble also. I'm sure there are many more people with trouble with the vehicles. I wish Dodge would step up to the truth. and recall their nightmares. I saw many of their 1996 Dodge trucks at their dealers shop with all the electrical pulled out.

SOURCE: unable to locate the fuel filter on my 2005 dodge magnum 2.7 liter

It's located in your fuel tank.

cheers.

SOURCE: 2005 Magnum: I lost my owners Manuel can u tell me which number...

the radio fuse is in the REAR POWER DISTRIBUTION CENTER next to the spare tire (under the cover). it is number 36, 20 amp, yellow.

Jeffrey Turcotte

• 8991 Answers
• Posted on Sep 21, 2010

SOURCE: how do I remove the

From autozone.com CAUTION On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.

1. Disconnect and isolate the negative battery cable.
2. Remove the instrument panel silencer from the passenger side of the instrument panel, as follows:
   1. Remove the two push-pins that secure the instrument panel silencer to the instrument panel.
   2. Pull the instrument panel silencer rearward to disengage it from the brackets located near the dash panel.
   c. Remove the instrument panel silencer from the vehicle.
   

5. Remove the blower motor from the HVAC housing.
Fig. Blower motor (2), harness connector (1), retaining screws (3) and HVAC housing (4)

To install

1. Position the blower motor into the HVAC housing.
2. Install the four screws that secure the blower motor to the HVAC housing. Tighten the screws to 20 inch lbs. (2.2 Nm).
3. Attach the wire harness connector to the blower motor and engage the wire harness connector locking tab.
4. Install the HVAC wire harness retainers onto the blower motor.
5. Install the instrument panel silencer onto the passenger side of the instrument panel, as follows:
   1. Position the instrument panel silencer into the vehicle.
   2. Install the instrument panel silencer above the brackets located near the dash panel.
   3. Install the two push-pins that secure the instrument panel silencer to the instrument panel.
   
   
6. Reconnect the negative battery cable.